Deep hole drilling and milling center

TBT Tiefbohrtechnik GmbH + Co BW200-1-800

The drilling method of the deep hole drilling machine is single-lip drill deep hole drilling.

Drilling Unit Information:
- Number of spindles: 1
- Infinitely variable spindle speed: 300 – 8000 rpm
- Spindle drive power: 7.5 kW
- Max. drilling depth: 800 mm
- Drilling diameter min/max: 3 – 25 mm based on ST 60
- Max. twist drilling: 25 mm
- Max. thread tapping: M24x3
- Milling material removal rate: 150 cm³/min

Travel Paths:
- X-axis travel: 800 mm
- Y-axis travel: 400 mm
- Z-axis travel: 630 mm
- W-axis travel: 800 mm

Travel Speed:
- X-axis speed: 15,000 mm/min
- Y-axis speed: 15,000 mm/min
- Z-axis speed: 15,000 mm/min
- W-axis speed: 15,000 mm/min

Fluid Information:
- Coolant supply: deep hole drilling oil
- Tank capacity: 800 liters
- 1x scraper belt chip conveyor
- 1x hydraulic unit and pneumatic system/equipment

- 1x submersible pump:
Pumping capacity: 200 l/min

- 1x low pressure pump:
Nlsdpow E H E Rofx Anksg
Pumping capacity: 100 l/min
Pump drive: 1.7 kW

- 1x compact belt filter:
Filtration capacity: 120 l/min
for processing steel/non-ferrous metals

- 1x radial piston pump with remote adjustment:
Pumping capacity: 2 – 94 l/min
Pump drive: 7.5 kW

Spindle Unit:
- Cartridge spindle design with drive housing and spindle drive with gearbox. Spindle bearing with precision angular contact ball bearings and lifetime grease lubrication.

Milling and Drilling Spindle Unit:
- For conventional machining
- Spindle head with HSK 50 tool holder

Drill Bush Holder:
- Design as 2-position turret with electric swivel mechanism
- Locating position via Hirth coupling
- Turret head with fixtures for:
Guide bushes for deep hole drilling
Milling and drilling spindle unit for conventional machining

Pickup Tool Changer:
- For conventional tools and drill bushings
- Disc magazine design with 20 stations including feed stroke

Automatic Tool Changer for Deep Hole Drilling Tools:
- Fixed ELB column magazine for at least 5 tools including automatic tool clamping for HSK holders

Clamping Table with W-Axis and NC Rotary Table:
- Length/width: 800 x 600 mm
- Positioning accuracy: B-axis +/- 30"
- Centric payload: 1,500 daN

Workpiece Clamping Device:
- 1x tailstock with manual clamping movement
- 1x NC dividing unit (A-axis) with manually operated two-jaw chuck for workpiece clamping
- 1x base plate for mounting and clamping drill bushings + supporting prisms

Electrical Equipment Information:
- 1x CNC control Sinumerik 840D (digital complete system), including PLC S7-300

Connection Data:
- Operating voltage: 3AC 400V ±10% – Frequency: 50 Hz
- Control voltage: 24 V DC
- Total connected load: 25 kW

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.