Edgebander

HOMAG KAL 210/7/A20/S2

TECHNICAL DETAILS

The machine has the following configuration: 

Minimum edge thickness: 0.3 mm
Maximum edge thickness: 3 mm
Maximum feed speed: 25 m/min
Pressure beam: with rubber conveyor belt
Panel stop: with CNC positioning
Panel infeed alignment system: available

Jointing Unit
Processing interval: automatic, time-controlled
Motor power: 3 kW
Speed: 9,000 rpm

Edge Application
Edge heating lamps: available
Roll magazine: available
Hotmelt adhesive tank: available
Hotmelt premelter: available
Number of pressure rollers: 7
Positioning: CNC controlled

End Trimming Unit
Number of motors: 2
Motor power: 0.8 kW
Speed: 12,000 rpm

Top and Bottom Flush Milling Unit
Number of motors: 2
Motor power: 1.5 kW
Speed: 12,000 rpm

Corner Rounding Unit
Manufacturer/Model: FF12
Number of motors: 4
Motor power: 0.4 kW
Speed: 12,000 rpm

Profile Milling Unit
Number of motors: 1
Processing interval: automatic, time-controlled
Motor power: 5 kW
Speed: 11,600 rpm

Scraper Unit
Manufacturer/Model: PN10

Glue Scraper Unit

Buffing Unit
Number of motors: 2
Spray device: available

MACHINE DETAILS

Number of processing units in edge processing: 7

Control system: PC22

EQUIPMENT
Pressure beam with rubber conveyor belt
Panel stop with CNC positioning
Panel infeed alignment system
Edge heating lamps
Roll magazine
Hotmelt adhesive tank
Hotmelt premelter
7 pressure rollers
End trimming unit
Top and bottom flush milling unit
Corner rounding unit FF12
Profile milling unit
Scraper unit PN10
Glue scraper unit
Buffing unit with spray device
PC22 control

The machine is sold and delivered in its actual and legal condition ("as seen and approved") on the basis of photo documentation and technical/commercial documents of descriptive character. The buyer has the right to inspect the goods prior to collection and assumes responsibility for installation, securing, and use of the machine at the destination.

External reference: 6042