Vacuum pressing system and preheating

ORMA DUPLEX 30/15

Lightly used ORMA MEMBRANE PRESS, model DUPLEX 30/15 vacuum press with preheating oven/table for acrylic and thermoform plastics. Has only seen occasional light project use. Suitable, for example, for processing Corian sheets. An alternative to buying a new machine.

Pressing area: 3000 x 1500 mm
Vacuum pressing force across the entire work area: 44 tons
11 tons/m2
Maximum pressing height: 500 mm

ORMA HEATING OVEN/TABLE 30/15 FOR ACRYLICS AND THERMOFORM PLASTICS

• Heating by electric resistors and air circulation
• Heated area: 3000 x 1500 mm
• Max height of workpiece: 100 mm
• Heating power: 18 kW
• Maximum temperature: 200°C
• Digital temperature control from the control panel

The unit's frame is made from welded thick steel beam structure and welded steel sheets.
There is an insulation layer between the galvanized steel sheets of the oven’s inner and outer surfaces.
Manual oven opening, guided rails, and transport wheels.
Membrane press bed is phenolic-coated plywood featuring a grid pattern for improved vacuum distribution.
The top section, where the membrane film is mounted, opens 45 degrees and is equipped with gas springs.
Quick and easy upper section locking. Manual membrane film quick-mount system.
Vacuum system with a single 25 m3/h vacuum pump.

Control panel, installed on the left side of the machine, includes:
• Main switch
• Control voltage indicator lamp
• Emergency Stop button
• Temperature monitoring/control
• Vacuum pump status light on/off
• Heater status light on/off
Kljdpexz Rhfjfx Aazjl

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.