KHS Innopack CA-1 Cardboard Erector (2006)

KHS Kartonauffalter

Overview
Prsdpfx Ajz Hcivenkob

This KHS Innopack CA-1, built in 2006, is a carton erector that forms cartons from flat blanks and closes their bottom with hot-melt glue. Blank stacks are fed on a roller conveyor into the magazine; suction grippers pick each blank, erect it, fold the inner bottom flaps, apply glue with a Robatech hot-melt unit, close and press the outer flaps and discharge the carton onto the outfeed roller conveyor. The machine is still installed in a wine bottling and packaging line and can be inspected on site.

Technical data

- Manufacturer: KHS
- Model: Innopack CA-1
- Year of manufacture: 2006
- Machine type: carton erector with bottom gluing
- Glue system: Robatech Concept hot-melt unit with glue nozzles for the bottom flaps
- Power supply: 400 V, 3 Ph, 50 Hz, 15 A
- Compressed air: min. 5 bar operating pressure
- Overall dimensions (L x W x H): 4,550 x 3,450 x 2,720 mm
- Blank infeed: roller conveyor with stainless steel rollers, roller width 1,000 mm, infeed clearance 800 x 450 mm
- Outfeed: roller conveyor with stainless steel rollers, roller width 300 mm, 3,050 x 650 x 880 mm

Equipment

- Stack preparation with automatic loading of the blank magazine
- Blank magazine with lifting device, side guides and front and rear stops
- Pick-up and erecting stations with vacuum suction grippers and vacuum unit
- Folding, gluing, closing and pressing devices for the carton bottom
- Side and height adjustment by handwheel for different carton sizes
- Enclosure with windowed safety doors
- Operator panel with display, keypad, start/stop, key switch and emergency stop; operator texts in French
- Control cabinet and pneumatic service unit
- CE marked; operating manual (Dutch) available

Condition

Still installed. An inspection on site is possible.

Availability

Available immediately. Location: Belgium.