Edge banding machine with return system

Homag KAL 310 + TFU 140

HOMAG KAL 310 + Panel Return Conveyor TFU 140!

TECHNICAL DETAILS

Profile Milling Unit FK11 manual
Edge thickness: max. 3 mm
Motors: 2 units
Motor power: 0.4 kW per motor
Frequency: 200 Hz
Speed: 12,000 rpm
Feed rate: max. 20 m/min
Feed rate during continuous trimming without profile trimming: max. 30 m/min
Panel length single-sided: min. 240 mm
Panel length double-sided: min. 120 mm
Panel thickness: 12 - 60 mm
Panel spacing with PC22: min. 500 mm
Minimum workpiece gap with workpiece thickness over 22 mm: min. 600 mm

Multi-Scraper MN21 Automatic
Number of profiles: max. 5 different profiles
Edge thickness: max. 3 mm
Panel thickness with radius R = 3 mm: min. 13 mm
Panel thickness with chamfer 0.5 x 45°: min. 10 mm
TC knives: 2 units
Chamfer angle: 20°
Radius: R = 1.5 / R = 2 / R = 3 / R = 5

Pre-milling Unit BF10
Motors: 2 units
Motor power: 0.55 kW per motor
Frequency: 200 Hz
Speed: 12,000 rpm
Swivel range: +/- 1°
TC cutter: 70 x 25 mm
HSK: 25
Cutting angle: 54°

Feed speed: 18-25 m/min
Workpiece thickness: 8-60 mm
Edge material coil: 0.3-3 mm

MACHINE DETAILS

Operating hours
Operating hours: 6,358 h
Feed time: 1,651 h

EQUIPMENT
Pre-milling
Automatic inlet fence adjustment
Infeed device with 2 rollers
Quickmelt application unit
2-roller magazine feed
Automatic pressure zone adjustment
Kapp unit HL84 with pneumatic adjustment
Flush trimming unit BF10 with pneumatic adjustment
Profile milling unit FK11
Multi-profile scraper unit MN21 for 5 different profiles