Development equipment

ECRM MAKO 8

ECRM MAKO 8 CTP —
Specification | MAKO 8
Type | CTP 8-page
Laser Technology | Violet 405 nm, single beam - 120Mw
Compatible Plates | Violet photopolymer and silver halide
Maximum Plate Size | 824 × 1,143 mm
Minimum Plate Size | 254 × 254 mm
Plate Thickness | 0.15 to 0.30 mm
Resolutions | 1,800 to 3,556 dpi depending on the media
Productivity | Up to 15 8-page plates/hour at 2,540 dpi
Reported Repeatability | 0.025 mm typical over 6 consecutive separations
Positioning Accuracy | ±2 µm with the Precision Drive System
Image Scaling | 85 to 110%
Workflow | TIFF 1-bit compatible via CtServer
Output | Online connection to processor
The machine therefore accepts a very wide range of formats, from 254 × 254 to 824 × 1,143 mm, which allows it to handle both small formats and genuine 8-page plates.
Exposure/Mechanical Section
The MAKO 8 uses a 405 nm violet laser. ECRM states that the single beam can be calibrated according to the sensitivity of the plate. The maximum resolution of 3,556 dpi also allows for the use of demanding screening techniques, including stochastic screening.
The system is mechanically quite interesting: the plate is positioned on a pin-bar registration system and then moved under the laser head by the Precision Drive System. The documentation specifies a positioning control of ±2 µm.
The registration system is interchangeable to accommodate notches corresponding to the presses used, which aims to improve plate/press registration and reduce setup time.
Dimensions and Installation
Width: 1,066.8 mm
Depth: 2,448.6 mm
Total Height: 1,892.3 mm
Weight: 409 kg
Power Supply: 100–240 V single-phase, 50/60 Hz
Maximum Power Consumption: 250 W / 3 A
Thermal Dissipation: 850 BTU/h
Operating Temperature: 17 to 30 °C
Relative Humidity: 45 to 65%, without condensation
Todpfxszxzm To Aggob

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.