High-speed radial drill

DONAU Danuport 540

Dimensions and travel paths
Tool holder SK 40
Table dimensions mm 4000 x 800
Number of T-slots 6
Distance between T-slots mm 140
Distance between spindle bottom edge min. mm 140
Table top edge max. mm 740
Drilling radius min mm 540
max. mm 1590
U-axis travel path mm 2600
Y-axis travel path mm 1050
Quill stroke (Z-axis) mm 200
Column stroke (W-axis) mm 400

Cutting values
Drilling capacity into solid material St 60 mm 40
GG 22 mm 50
Thread cutting St 60 M 36
GG 22 M 42

Main spindle drive
AC motor, frequency-controlled kW 5.5 at 100% duty cycle.
Speed range: min -1 15 - 2800
Torque Nm max. 250
constant from min -1 15 - 200
Feed drives
X-axis - AC servo motor kW 0.25
Y-axis - AC servo motor kW 0.25
Z-axis - AC servo motor kW 4.50
W-axis - AC servo motor kW 2.50
U-axis - AC servo motor kW 2.50
Rapid traverse speeds (X/Y/Z): m/min. 7.5 / 7.5 / 5
Rapid traverse speeds (U/W): m/min. 7.5 / 3
Feed rates infinitely variable mm/min. 5 - 2000
Feed force N 12000

Accuracy
Positioning accuracy X, Y axis
up to 1200 mm mm ± 0.075
Repeatability X, Y axis mm ± 0.03
Positioning accuracy Z axis mm ± 0.05
Pjdpjv If T Tofx Agrera
Repeatability Z axis mm ± 0.03
Positioning accuracy W axis mm ± 0.05
Repeatability W axis mm ± 0.03

Electrical data
Operating voltage / frequency V / Hz 400 / 50
Control voltage V 24
Total connected load kVA 13.0

CNC control
Axes: 5 (X, Y, Z, W, U), expandable
Screen: TFT flat screen backlit, easy to read from all sides
Position information: Cartesian or polar, dimensions absolute or incremental,
Unit of measurement: mm or inch or in degrees
Interpolation: 2 axes (X, Y)
Technology database: tool management, tool suggestions according to machining type, cutting data suggestions depending on material
Tool management: max. 500 tools
Sub-program technology: yes
Machining cycles: cycles for centering, drilling, thread cutting,
reaming, countersinking and boring, freely programmable cycle for special tools, dwell time possible for each cycle
Chip breaking / chip removal: possible for drilling cycle
Drilling patterns: row of holes, circle of holes, matrix
Basic software: programming in dialog, 38 zero point shifts, turning and mirroring, teach-in for X, Y, Z, restart in the program with optional functions for targeted entry
Zero point determination: cycles for determining zero points by manually
touching the workpiece for:
- any clamped right-angled parts
- any clamped round parts
- mediation of cast and burnt parts
- Angular position detection for round parts by touching
- reference edges or surfaces
Data interfaces USB interface

Painting (new painting)
Standard painting, two-component textured paint
Machine upper part light gray RAL 7035
Machine lower part signal blue RAL 5005

Documentation
Operating and programming instructions
Electronics circuit diagram
Spare parts drawings
Test report for mechanics, electrics and safety equipment

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.