High-speed radial drilling machine

DONAU Danuport 540

Dimensions and Travel Ranges
Tool holder: SK 40
Table dimensions: mm 4000 x 800
Number of T-slots: 6
T-slot spacing: mm 140
Distance:
- Spindle bottom edge: min. mm 140
- Table top edge: max. mm 740
Boring radius:
- min. mm 540
- max. mm 1590
Travel range U-axis: mm 2600
Travel range Y-axis: mm 1050
Quill stroke (Z-axis): mm 200
Column stroke (W-axis): mm 400

Machining Data
Drilling performance in solid material:
- St 60: mm 40
- GG 22: mm 50
Thread cutting:
- St 60: M 36
- GG 22: M 42

Main spindle drive
AC motor, frequency-controlled kW 5.5 at 100% duty cycle
Speed range: min-1 15 - 2800
Torque: Nm max. 250
Constant from: min-1 15 - 200

Feed drives
X-axis - AC servo motor kW 0.25
Y-axis - AC servo motor kW 0.25
Z-axis - AC servo motor kW 4.50
W-axis - AC servo motor kW 2.50
U-axis - AC servo motor kW 2.50
Rapid traverse speeds (X/Y/Z): m/min 7.5 / 7.5 / 5
Rapid traverse speeds (U/W): m/min 7.5 / 3
Fpodpfoy Ttrtjx Ac Dji
Feed rates, infinitely variable: mm/min 5 - 2000
Feed force: N 12000

Accuracy
Positional accuracy X, Y axis at 1200 mm: mm ± 0.075
Repeatability X, Y axis: mm ± 0.03
Positional accuracy Z axis: mm ± 0.05
Repeatability Z axis: mm ± 0.03
Positional accuracy W axis: mm ± 0.05
Repeatability W axis: mm ± 0.03

Electrical data
Operating voltage / frequency: V / Hz 400 / 50
Control voltage: V 24
Total connected load: kVA 13.0

CNC control
Axes: 5 (X, Y, Z, W, U), expandable
Screen: TFT flat screen, backlit, easily readable from all sides
Position data: Cartesian or polar, dimensions absolute or incremental,
Unit of measurement: mm or inch, or in degrees
Interpolation: 2 axes (X, Y)
Technology database: Tool management, tool suggestions according to machining process, material-dependent cutting data suggestions
Tool management: max. 500 tools
Subprogram technology: yes
Machining cycles: Cycles for centering, drilling, threading, reaming, countersinking and boring, freely programmable cycle for special tools, dwell time possible in each cycle
Chip breaking / chip removal: possible in drilling cycle
Drilling patterns: Hole pattern, hole circle, matrix
Basic software: Programming in dialog mode, 38 zero-point offsets, rotation and mirroring, teach-in for X, Y, Z, restart in program with selection functions for targeted entry
Zero point determination: Cycles for determining zero points by manually probing the workpiece for:
- any clamped rectangular parts
- any clamped round parts
- aligning cast and sintered parts
- Angle detection for round parts by probing the reference edges or surfaces
Data interfaces

Paint finish with signs of use
Standard paint finish, two-component textured paint
Machine upper part: light grey RAL 7035
Machine lower part: light blue RAL 5012

Documentation
Operating and programming manual
Electrical wiring diagram
Spare parts drawings
Test report for mechanics, electrical system and safety devices

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.