Cyclone Pre-separator

D&M Z-Line

For suction diameters from 120 to 700 mm.

Please provide your volumetric flow rate, and we will select the right cyclone for you.

Various designs available:
- Legs made of painted square steel profiles
- Cell wheel lock and transition piece with inspection flap
- Inlet box with check valve
- Tangential outlet with/without pressure relief area
- Square outlet with/without pressure relief area
- Sound insulation

Of course, you can also purchase all accessories from us, such as fans, suction pipes, deflector hoods, etc.

Mode of operation:
The contaminated air is introduced tangentially into the cylindrical upper part, causing the air to rotate. The material is forced outwards towards the circumference of the cyclone under the influence of centrifugal force and is discharged through the hole in the bottom. The cleaned air leaves the cyclone through the centrally located outlet pipe at the top.

The separation efficiency increases with the feed rate, but so does the pressure loss and, consequently, the energy consumption. Therefore, it is important to find a good compromise.

We have developed a range of cyclones that are optimized for filtering large quantities of material. They are therefore very well suited for the wood/paper/recycling/grain and feed industry.
Kdedpfjftb Ebjx Afaep

Below, you can select the cyclone with the appropriate size based on the air volume and a typical pressure drop in the range of 1000 Pa.

Operating pressure +/- 5000 Pa

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.