Laser Punch Press

TRUMPF TruMatic 6000 (K01G) 3200 Watt FMC

X working area max.: 3085 mm
Y working area max.: 1650 mm

Control: Siemens Sinumerik 840 D
Laser power: 3200 Watts
Operating hours: Power supply 41,117 h
Laser ready 37,005 h
Laser beam on: 7,365 h

Standard equipment:
- Hi-Las high-pressure cutting
- Laser cutting head with 5'' lens
- Laser cutting head with 7.5'' lens
- Quick-change device for cutting heads
- Programmable cutting gas selection/pressure setting
- Capacitive height control (DIAS III)
- ContourLas function
- Slag cone detection
- Compact dust extractor
- Tank heater
- Automatic tool changer with 17 stations (21 – clamping claws)
- 3 clamping claws
- Rotation of all tools
- NC-controlled, digital, maintenance-free three-phase drives
- Automatic repositioning
- Tool length compensation
- Fast shutoff of hydraulics
- Automatic shutdown
- Automatic part slides, each 500 x 500 mm
- Sensors for both part slides
- 2 good-part bins
- Scrap slug extraction
- Forming capability
- Programmable punching tool lubrication
Crodpow I Rq Isfx Abfoh
- Programmable hold-down device
- Adaptive stroke length control
- Safety devices

- Remote diagnostics unit
- RJ 45 network connection
- 3.5'' floppy disk drive

+ Warp detection
+ Blow-off device for small parts
+ AutoLas Plus (FocusLine)
+ Function for deburring and roller technology
+ Function for thread forming with thread former breakage monitoring
+ MultiShear function
+ MultiTool function
+ Marking/fast beading function
+ Softpunch function
+ Low-scratch processing
+ Repositioning cylinder
+ Vibration-damped installation
+ Chip conveyor with tipping container
+ Additional clamping claw

Automation:
+ Peeling system
+ GripMaster (3000 x 1500 mm)
+ SheetMaster (3000 x 1500 mm)
+ Lift table (300 mm)

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.