3d printer

SLM Solutions 280

SLM Solutions
Type: SLM 280 HL
For sale is a professional metal 3D printing system, type SLM 280 2.0,
from SLM Solutions (Lübeck).
The SLM is designed for 24/7 operation and was last used with titanium.
Dcsdezhlr Ejpfx Am Tjk

Installation was in 2018. The system already has the sintering walls for gas flow.
The system has been running on argon for the last 3 years.
Approx. 50,000 laser hours.
The 50,000 hours refer to the laser-on time; the exposure time is not recorded in the older 280 models.
If I disregard the coating time, I estimate approximately 10,000 active laser hours.
Last maintenance was at the beginning of 2026.

Currently, occasional communication issues between the PC and the PLC are observed.
In rare cases, this can lead to incorrect status messages, which can cause the system to be briefly interrupted during
an ongoing job.
Technical data (excerpt)

Single laser 400W
Weight: 1,245 kg
Build volume: 280 × 280 × 365 mm
Laser: 1 × 400 W fiber laser (IPG)
Optics: 3D galvo system
Focus diameter: 80 – 115 µm
Max. scanning speed: up to 10 m/s
Layer thickness: 20 – 90 µm
Minimum feature size: approx. 150 µm
Build speed: up to approx. 113 cm³/h (material-dependent)
Materials: Stainless steel, tool steel, titanium (Ti64), aluminum, Inconel, CoCr
Inert gas: Argon
Gas consumption process: approx. 2.5 – 8 l/min
Gas consumption purging: approx. 70 – 110 l/min
Compressed air: approx. 6 – 7 bar
Electrical: 400 V, 3P+N+PE
Fuse: 63 A
Power consumption: approx. 3.5 – 5.5 kW
Machine dimensions: approx. 2600 × 1200 × 2700 mm
Weight: approx. 1300 kg (empty), up to approx. 1800 kg (including powder)
Important note:
"The table shown in the photos is not included in the sale."
Condition: used
Scope of supply: (See picture)
SLM 280 machine
Control cabinet
Process chamber
Internal operating panel with screen
(Changes and errors in the technical data are subject to change!)
We will be happy to answer any further questions you may have by phone.

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.