Drying and Burn-in Furnace TRO, Model I

Siebdruck-Service Eickmeyer GmbH TRO, Model I

Drying and Burn-in Furnace TRO, Model I
Kljdpfed I T Exjx Aazol
For drying racks with max. 50rods, useable size 60x90cm, outer dimensions: approx. 2290mm wide x 1390mm deep x 2230mm high, useable space: approx. 1400x1070x1660cm. Suitable for vaporisation of low amounts of solvent, authorised for inks and solvents up to hazard class A II, according to safety requirements DIN EN 1539. Equipped with control of the minimum exhaust volume and a heating system in regard to the exceedance of the max. temperature. Fixing and drying temperature: up to max. 180°C. Power connection: 400V/50Hz, 21kW, weight: approx. 650kg, varnishing: corps RAL 7035 (light grey), doors RAL 7037 (dust grey). Special varnishing upon request.
Chamber dryer, all-steel construction, with good thermal insulation. Simple insertion of drying racks by means of easy-to-open wing doors. The air is sucked out of the drying chamber by ventilators, is blown through thermostat-controlled heating registers and re-fed temperature-controlled to the drying chamber. The solvents released during the drying process are dissipated from the exhaust side of the ventilator while supply air gets into the drying chamber. The horizontal air guide in the drying chamber guarantees an even temperature control. The required temperature can easile adjusted via actual and nominal value thermostat. Overheating protection by safety thermostat. Particularly suitable for fixing and drying of textile inks, flock glues as well as for burning-in of plate and aluminium signs up to 180°C. - Various drying racks for different applications available. - We recommend the installation of a gas warning unit. Delivery time 10-12 weeks. ATTENTION: Not permitted for solvents! Not permitted for foods!