Circular saw for light metal & aluminium

Pressta Eisele PROFILMA 502

Circular Saw Fully Automatic PROFILMA 502 + Chip Extraction Unit MG 3

ST Circular Saw Fully Automatic PROFILMA 502 1 69,430.00 69,430.00
Fully automatic operation, drive 7.5 kW, S6, 400 V, 50 Hz, 2850 RPM.
Lsdoy Dtpmspfx Advjaa
For use with saw blades Ø 550 mm, cutting range 270 x 150 mm (width x height), Ø 190 mm.
Max. profile width 270 mm, Siemens S7 control system with touch display including piece counter.
Including CPU 315 and Flexisoft, piece count multiplier for bundle cutting operations.
Cycle time indicated in seconds, chain dimension, including reversing device for section lengths up to 4 m max.
Automatic shut-off via limit switch at end of workpiece, error diagnostics, including IXON router for VPN connection, see datasheet.
Motorized saw blade feed, continuously adjustable, vertical and horizontal clamping from below upwards, feed and discharge side at the saw head, cutting gap expansion on both sides of the saw blade.
Electronic material feed unit, 800 mm feed length, with ball screw and servomotor, including pneumatic horizontal and vertical clamping device.
The profile support area in the feed section is equipped with a liftable/lowerable roller, remnant piece from 75 mm, depending on profile.
Clamping pressure reduction horizontal and vertical with 6 pressure regulators, timed spray device with fill level monitoring and automatic shut-off, lubricant container 1 liter, noise protection package, frame internally lined with sound insulation mats.
2 extraction ports Ø 100 mm, safety guard above the saw head and feed unit, 740 mm roller conveyor with reach-in protection on the infeed side, 450 mm Pertinax table plate with reach-in protection on the discharge side.

Chip Extraction Unit MG 3
Dust and chips are collected in a 172-liter metal container, which is detachable for easy emptying.
2 outlets with 100 mm hose adapters, without extraction hose, drive 3.0 kW, 400 V, 50 Hz, three-phase motor.
Max. air flow rate 2,600 m³/h, vacuum 30 mbar, with fan snail housing above the extractor.
Large filter surface, pneumatic shaker unit for filter cleaning, filter class M, maximum noise level 80 dB(A).
Selector switch for continuous operation or operation controlled by the saw, without power cable, paint finish: RAL 7035 / 9016.

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.