Double cross cut saw

Omga TRF 527 NC FP CA MM.4000

DOUBLE GLASS BEADING SAW TRF 527 NC FP CA MM.4000 (according to nameplate)

Double mitre saw for simultaneous cutting of two superimposed glass beads.
Right saw unit is fixed;
Adjustment of the left unit is based on the set cutting length, which can be read from a digital display.
Units are equipped with supports that enable simultaneous cutting of 2 glass beads.
For cutting larger cross-sections, the upper support can be removed.
After the cutting process is completed, the pneumatic clamping cylinders automatically swivel to the side to simplify loading and unloading of the machine.

STANDARD EQUIPMENT
Nodpfxsy Er Ike An Tocr
• Fixed unit on the right
• Digital measurement display
• Pressure monitor
• 2 HM-tipped saw blades
• Electrical system with motor brake, undervoltage release and motor protection switch
• Pressure monitor
• Tool kit
• Safety covers with horizontal, swiveling clamping devices
• Two-hand control
• Belt drive
• Pneumatic unit lift
• Central support

TECHNICAL DATA
• Motor output 2 x 1.2 kW
• Saw blade diameter Ø 220 mm
• Max. cutting height without support 80 mm
• Max. cutting width at 90 degrees 55 mm
• Max. cutting width at 45 degrees 40 mm
• Max. cutting length 4000 mm
• Min. cutting length 158 mm
• Weight approx. 290 kg
• Space requirement (standard equipment) approx. 4,500 x 1,000 mm

1 set of 2 mechanical stops for setting up to 4 intermediate angles. Additional central support.
1 set of adjustments for rebated profiles
1 set of adjustments for rebated profiles according to drawing:
- Adapter on the clamping devices to compensate for profile inclination
- Shims on the rear stops of the units and the central piece. The sketch below (in green) shows a beveled presser following the inclined profile and pressing it against the (red) shim on the stop.

Details provided without guarantee.

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.