Contour and surface measuring system

Mahr MarSurf CD 120 / CT120 Komplettsystem

Mahr
Mahr MarSurf CD 120 / CT120 Complete System
For sale is a professional contour and surface measuring system from Mahr, consisting of several devices, accessories, calibration standards, and extensive training documentation.

This is a high-quality laboratory or quality measurement system for precise analysis of surface geometry, contours, and measurement parameters.

Main unit:
Mahr MarSurf CD 120 (Contour Measuring System)
CNC contour measuring instrument with vertical axis system
Precision measuring module with stylus holder
Granite measuring plate with guides
Suitable for contour measurements on technical components

Typical measuring ranges:
Vertical (Z-axis): approx. 60–120 mm (model-dependent)
Horizontal (X-axis): approx. 100–120 mm
Extremely high accuracy due to granite base and backlash-free guides

Control units:
Mahr MidRange / MidRange CNC (Type MCP-22 / MCP-23)
Control and operating unit for the axes
Interface for measurement software (MarWin / MarSurf XC)
Mahr ST 500
External control or sensor module (often for special probes)

Software and Documentation Status
MarSurf XC2 V. 3.01–03.4
MarSurf XC20 V. 5.00–10.1
MarWin v13.20-07
Chsdpfxex A Ur Rs Ag Ijf
Operation manuals, training folders, training documents
Measuring examples, diagrams, technical instructions

This software is designed for evaluating contours, profiles, and surface parameters.

Accessories / Measuring and Calibration Parts
Stylus and probe arm sets
Precision styluses of various shapes and lengths
Replacement needles and mounting tools
Stylus holder with protective case
Calibration and reference pieces
Mahr Contour 2 Block with reference sphere
Calibration and parameter data
For PCV, CD 120, LD 120
CDs and data carriers with parameters and software
Transport and protective cases
Several original cases with foam inserts
Calibration seal/inspection sticker visible (valid until 2026)

Typical voltage data for the Mahr MarSurf / MidRange / CT series
MarSurf CD 120 (Contour measuring unit / axis drive)
Supplied via control unit
Internal usually: 24 V DC
External power supply via MidRange control unit
Mahr MidRange control unit (MCP-21 / MCP-22 / MCP-23)
This device is the central power supply unit.
Typical values:
Primary: 230 V AC / 50-60 Hz
Secondary: 24 V DC (regulated)
Power consumption: approx. 40–80 W
Mahr ST 500
Also connected to the MidRange system
Powered by 24 V DC
CT120 / Probe systems
Sensors operate at low voltage 5–24 V DC
Supplied by the main unit (no separate power supply)
Accessories, manual control units, interface boxes
Usually 5 V or 24 V DC, depending on module
Weight: approx. 65–73 kg

Important note:
"The table shown in the photos is not included in the sale."
Condition: used
Scope of delivery: (see photo)
(Subject to change and errors in the technical data and specifications!)
Further questions can be answered by phone.

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.