48V belt starter generator test bench

Kübrich Komponentenprüfstand

Kübrich
Kübrich Test Systems 48V Belt Starter Generator - Component Test Bench
Details of the test bench: (See Figure 13)
Frame with
(1) Mounting device for a belt starter generator
(2) Load machine
(3) Belt
(4) MP1: Control cabinet
(5) MP3: Control cabinet for control, interface panel with main switch, I/O
(6) MP2: Control cabinet with Simotion
(7) MP4: Control cabinet with DC-DC converter
(8) H3: Measuring technology box
(9) H4: Interface box
Intended use:
The test bench is used for conducting tests on belt starter generators during development.
Technical data:
Electrical connection data
Power supply: 400 V / 32 A
Battery simulation: 0 - 60 V
Current: 0 - 250 A (continuous)
Current: 330 A (briefly, less than 1 s)
Control voltage: 24 V
Mechanical performance data according to the data sheet of the load machine
Note that a gear ratio of 1:2 to the test specimen shaft must be observed.
Rotational speeds:
Gjdpfxjzhkb Sj Aivekc
Load machine:
Manual operation: 0 - 50 1/min
Automatic operation: 0 - 10,000 1/min
Test specimen motor:
Manual operation: 0 - 100 1/min
Automatic operation: 0 - 20,000 1/min
Dimensions and weight
Width: 850 mm Height: 1386 mm Length: 1687 mm
Weight: approx. 1.2 t
Condition: used
Scope of supply: (See Figure)
(Changes and errors in the technical data and details are subject to change!)
We will gladly answer any further questions you may have by telephone.

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.