Hydraulic press

Hidrogarne/Garnet MV-800/NC SINCRO

We are offering here a new build of the machine shown. The machine was put into operation in 2020 and can be inspected by the customer.
Cedpfjwlrv Usx Abforh
Technical data:
Press force T 800
Opening force T 80
Motor power KW 55/75 + 55/75
Piston stroke 1000mm
Rapid pre-fill speed mm/s 110
Working speed mm/s 6
Return speed mm/s 180
Guide diameter mm 250
Max pressure Bar 250
Useful table area mm 3,500 x 2,000
Lower table displacement mm 2000
Between columns mm 2,000
Open height mm 1500
Total front mm 3800
Total side mm 4500
Total height mm 6400
Weight kg 134,600

The MV-800E/NC-SINCRO press was specially developed for the adjustment and testing of molds, dies, and stamps.

The 4 columns with 250 mm diameter made of C45E steel were specially manufactured for high stress.

It features an optimized hydraulic system with a pressure of up to 250 bar, ensuring long service life and reliability.

It meets all essential safety and health requirements according to CE regulations.


STRUCTURE AND TABLE
• A structure that withstands 600 T concentrated force on 1/3 of its surface.
• Lower table with T-slots.
• Upper table with T-slots.
• Usable table surface: 3,000 x 2,000 mm.
CYLINDER AND HYDRAULIC UNIT
• Two double-acting hydraulic cylinders with 400 T each.
• Single-stage hydraulic unit with automatic shutoff of pre-fill speed and independent operation, equipped with a decompression system and proportional pressure pre-fill valves. Equipped with digital potentiometers on the upper table for displacement control and an electronic synchronization system to compensate for off-center or unbalanced forces.
• The press is equipped with a side pressure switch to regulate the most suitable pressure setting for each specific task.
• Glycerin manometer with tonnage display.
ELECTRICAL INSTALLATION AND SAFETY
• Electrical installation for operation with 1 or 2 speeds of the main cylinder feed.
• The press has a manual cycle and an automatic cycle (activated via a test button selector):
• The manual cycle allows the execution of all movements (step by step) of the press at slow speed.
• The automatic cycle allows the press to perform a complete production cycle.
• Electrical safety system for the upper table fall protection system.
• Lower table with hydraulic removal and physical stops.
• The machine features a control panel with a touchscreen display for entering operating and calibration data.
• 2 optical barriers of 1,000 mm with safety level IV installed at the front and rear.
• Electrical components from Siemens are manufactured according to applicable CE regulations and laws in protection class IP55.
• Electrical and hydraulic functions are redundant and self-controlled. Includes an additional safety block and self-monitoring devices for operation and safety. Includes inspection and certification of correct operation and safety distance for light barriers.
• Safety is ensured by a laser and area protection with light barriers of level IV.

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.