Flanging and assembling line

GMA CE GMA QUATRO 1611-22 + GMA NORIA 1213-35 l

Flanging and assembling line
GMA QUATRO 1611-22 flanging machine in-line with GMA NORIA 1213-35 assembling machine
4 punching mandrels (segments)
various template diameters available
shaping and gluing equipment including collar
single-point gluing with Nordson hot melt adhesive
manufacturer GMA CE, France
flanging machine GMA QUATRO 1611-22 operation options:
MANUAL OPERATION:
having supplied the magazines with pre-cut blanks
adjusted the flanging machine on the required box height
Dkodov U D Txopfx Aikon
set the disconnecting with handle on I on the side of the cabinet
to open the lockable air disconnecting switch
position the key button "automatic/manual" on "manual"
press on the push-button "reset"
wait until the heating temperature is reached
the flanging machine is set into operation : blue light : flickering - fixed
press on the green button "general ON / OFF"
the setting into operation of the flanging machine may be carried out either on the cabinet with the push-button
"stroke/stroke" or from the manual control casing where it is also possible to start the "stroke/stroke" operation
AUTOMATIC OPERATION
proceed in the same way as for the manual operation up to the phase "heating temperature standby"
set the belts into operation using the button "belt ON/OFF" located on the cabinet of the assembling machine
position the key button "automatic/manual" on automatic
press on the green button "flanging machine general ON/OFF"
the flanging machine is set into automatic operation