Veneer machine with direct stacking FISCHER & RÜCKLE FZR15 / DAR 22 (2009)

FISCHER & RüCKLE FZR15 / DAR 22

- Veneer strip lengths (fiber direction): 350-1500 mm
- Veneer strip widths (cross-fiber direction): 50-500 mm
- Veneer surface width (cross-fiber direction): min. 260 mm
- Veneer strip thickness: 0.3-1.5 mm

Veneer machine with direct stacking
Rcedpfxozuz Hle Abnjh
Manufacturer: Fischer & Rückle
Type: FZR 15 / DAR 22
Year of manufacture: 2009
Cross-feed splicer
For the most efficient cross-gluing of parallel-joined veneer strips into endless or component-specific veneer surfaces. The cut or rotary-cut veneers must be pre-glued, using PVAc or urea adhesives. This cross-feed splicer is the most economical alternative to longitudinal splicers for cross-fiber applications.
Production
Approx. 17-20 joints/min
Technical data
Veneer strip lengths (fiber direction): 350-1500 mm
Veneer strip widths (cross-fiber direction): 50-500 mm
Veneer surface width (cross-fiber direction): min. 260 mm
Veneer strip thickness: 0.3-1.5 mm
Equipment
Feeding device for efficient and convenient semi-automatic feeding of veneer strips.
Panel automatic for component-specific surfaces with pre-sorted components and a pre-selected number of veneer strips.
Features
- Perfect bonding of cut or rotary-cut veneer of all wood species, even with wavy or undulating veneer
- Unique, tried-and-tested horizontal pressing system that results in completely closed, solid glue joints
- Solid, robust construction for a long service life, reliable and fail-safe operation
- Easy operation thanks to screen, clear symbols, separate pressure gauge with direct access, etc.
- Liftable pressure beams for quick and easy access to the heating plates for cleaning
- Few wear parts, low costs for service and maintenance

Cross-cutter
For cutting to a pre-set format width (across the fiber direction) immediately after splicing. The straight alignment of the veneer must be observed and, if necessary, corrected by pressing a button. When working in endless mode, the required distance to the direct stacking device is set.
Direct stacking device DAR-22
For outputting and stacking the veneer surface immediately after splicing or cutting. The spliced surfaces are gently output and stacked without this compact direct stacking device exerting any mechanical forces.
Min. veneer sheet lengths (fiber direction): 350* - 1500 mm
Veneer sheet widths (across the fiber direction): 260 - 500* - 2200 mm
Stack removal from the left, right, or rear
Max. stack height: 500 mm
*Reliable stack alignment not guaranteed

Note:
The technical data and descriptions are a transcript of the original order confirmation. The data is for informational purposes only and is not binding.

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.