Reinforced Steel - Bending Machine

FALKEN // GMS MAX 40

bending diam. - max. 36.0 mm ST
cutting thickness max. 36.0 mm ST
motor 1450 U/min
oil volume 32.0 l
motor 380 Volt 50 Hz
total power requirement 5.5 kW
weight 650 kg
range L-W-H 1470 x 1200 x 1020 mm
Exhibition machine - NEW (!!)

Equipment:
- Maximum performance, minimum consumption
- hydraulic combination machine for bending and cutting processes
* for e.g. structural steel or solid material
- Bending mode with 3x different angle settings
- manual and automatic mode selectable
- simultaneous bending and cutting processes when the machine is in operation
- "ECO mode" = hydraulic pump only runs when the foot switch is pressed
- freely movable foot switch
- operating instructions

technical data:
- steel 45 kg / mm² .. bending Ø 36.0 mm / cutting Ø 36.0 mm
* for 2x pieces - steel 45 kg / mm² .. bending Ø 20.0 mm / cutting Ø 24.0 mm
- steel 65 kg / mm² .. bending Ø 32.0 mm / cutting Ø 32.0 mm
Rcodpfx Absxabntjnjh
* for 2 pieces - steel 65 kg / mm² .. bending Ø 18.0 mm / cutting Ø 20.0 mm
- steel 85 kg / mm² .. bending Ø 26.0 mm / cutting Ø 28.0 mm
* for 2 pieces - steel 85 kg / mm² .. bending Ø 14.0 mm / cutting Ø 18.0 mm

* Machine video:
?v=zagTSA81VyA