Plate Shear - Hydraulic

EHT TSS 4-31

sheet width 3100 mm
plate thickness 4.0 mm
thickness at "Niro-steel" 2.5 mm
cutting angle adjustment 1.0 °
back stop - adjustable 10 - 1000 mm
adjustment speed 180 mm/s
down holder 21 Stück
strokes per minute 18 - 31
oil volume 160 L
Control ELGO P8511
column arm 200 mm
distance between columns 3050 mm
0 max. 300 bar
voltage 400 V
main drive 9.0 kW
weight of the machine ca. 4800 kg.
dimensions of the machine ca. 3660 x 2070 x 2140 mm
from a maintenance workshop

Equipment:
- electro-hydraulic sheet metal shear "swing cut"
- machine frame = all-steel welded construction
- ELGO NC control model P8511, control panel at the front left
* for positioning the electro-motoric rear stop
Dedjxab Tvjpfx Aqtoku
* target/actual position value input possible
* adjustment by three-phase motor via toothed belt
- support table with ball rollers
* there are recessed grips between the table plates
- front finger guard
- hydraulically acting sheet metal hold-down device
- 1x freely movable foot switch
- emergency stop button at the front
- movable scrap switch
- original operating instructions + circuit diagram

Special accessories included:
- EHT pneumatic sheet metal holding device for thin sheet metal cuts
- 1x EHT extra long side stop 3.000 mm with mm scale & support foot
- 1x EHT extra long support arm with 3.000 mm with scale & Support foot
- EHT additional support arms with mm scale