DRILLING MACHINE

Collet RS 2-1

By placing a bid, you commit to collecting the machine by 28.01.2026! A timely appointment is necessary after the auction ends, as the machine has not yet been dismantled!

TECHNICAL DETAILS

Working spindle diameter: 100 mm
Working spindle taper bore: ISO steep taper No. 50
Drilling depth in one pass: 710 mm
Lowest position of spindle center above table surface: 0 mm
Highest position of spindle center above table surface: 1,200 mm
Maximum distance between spindle sleeve and tailstock: 2,300 mm
Horizontal travel of tailstock: 1,300 mm
Spindle speed: 6 - 1,250 rpm

Clamping surface of the table: 1,120 mm x 1,250 mm
Longitudinal travel of the table: 1,300 mm
Transverse travel of the table: 1,200 mm

34 feed rates for spindle, headstock, and table: 0.017 - mm/rev.
Feed rates for headstock and table, stepless: 20 - 1,000 mm/min
Rapid traverse for all axes: 2,800 mm/min

MACHINE DETAILS

Main motor power: 11 kW
Main motor speed: 1,450 rpm

Current type: Three-phase
Voltage: 380 Volt
Frequency: 50 Hz

EQUIPMENT
Documentation incl. wiring diagram
Circuit diagrams
Operating manuals

Note: Brake defective, clutch dismounted (included). Repair costs in Germany approx. €3,000.