Injection molding machine

YIZUMI FF120 (Vollelektrisch)

Base machine: FF120 IU320 D=30
Fully electric IMM. Ejector, nozzle system, core pulls servo-hydraulically controlled.
Clamping force 120T
Tie bar spacing 480x480
Tool installation height 150 to 580
Robot interfaces Euromap 18 and Euromap 67

Warranty can be optionally extended to 24 or 36 months.

Suitable 12 kg linear robot available upon request.

Optional equipment:
CE
Maximum tool height increased to 580 mm
Bimetallic plasticizing up to GF 30%
Interface for conveyor belt
Electric quick-change system for the cylinder with Harting interface
2 additional hydraulic core pulls with limit switches
2 air blow devices, permanently mounted on the stationary platen
Dosing signal interface with HAN-3A connector
Additional power supply: 220 V, 10 A, Schuko socket
20-mA interface for mold temperature controller
One water distributor 4 × 2 on the rear of each platen with 3/8" connections
2 water distributor batteries with 4 lines each
Socket package:
3 × 220 V / 16 A Schuko sockets
2 × 400 V / 16 A CEE sockets
1 × 400 V / 32 A CEE socket
3 freely programmable input/output signals
Centering rings on both platens according to Euromap 18 / 67

Standard equipment:
Clamping unit
· Clamping unit with automatic central lubrication
· Clamping movements via proportional valve control
· Hydraulically operated ejector plate
· Tool protection
· Variable adjustment of the clamping force possible
· Ejector protection
· Mechanical robot interface Euromap 18
· Footboard protection under the clamping unit from D1 1100 and larger
· Precision leveling shims between machine frame and customer floor
· Platens with threaded holes and T-slots, see technical data
· Automatic central lubrication (with grease)
· Ejector plate

Injection unit
· Hydraulic dual-cylinder injection
· Thermally insulated plasticizing unit
· 10-stage adjustment of the injection speed
· (Control parameters: speed; pressure; position)
· 10-stage adjustment of the holding force (Control parameters: speed; pressure; position)
· 5-stage adjustment of the plasticizing speed
· (Control parameters: speed; pressure; position)
· Plasticization supported on linear guides
· Hydraulic nozzle system
· Cold start protection
· Screw retraction function
· Automatic shut-off
· Measuring system for screw position

Electrical system
· Plasticizing heater via PID control
· Manual, semi-automatic and fully automatic operation possible
· Maintenance interface
Nedpfszzn Hljx Al Nelh
· Automatic alarm system with horn
· Unlimited technical parameter memory
· Automatic tool height adjustment
· Emergency stop function
· Online cycle analysis
· 12" TFT touch operating panel
· Visualized graphic program
· PDP interface
· Injection monitoring
· Tool closing monitoring
· SPC interface
· IP54 standard
· Screw speed measurement
· 16-level password security
· Euromap 12
· Automatic overheating protection

Hydraulic system
· Quiet servomotor hydraulic system
· Energy-saving servomotor hydraulic system
· High-performance servopump system
· Back pressure control via proportional valves
· Oil preheating
· Injection and tool closing monitoring
· Automatic pressure and flow calibration
· Oil temperature and oil level alarm

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.