Laser punching machine

TRUMPF TruLaser Cell 8030 L45

Note: The machine is displaying an error indicating defects in the laser source. The replacement parts recommended by Trumpf cost approximately €30,000.

TECHNICAL DETAILS

Working Area
Travel path X-axis: 3,000 mm
Travel path Y-axis: 1,300 mm
Travel path Z-axis: 600 mm
Travel path B-axis: ±135°
Travel path C-axis: n × 360°
Working height: 605 mm

Laser
Model: TruDisk 3001
Laser power: 3,000 W
Pulse frequency: 10 Hz–100 kHz

Axis Speeds
Simultaneous axis speed: max. 173 m/min
X-axis: max. 100 m/min
Y-axis: max. 100 m/min
Z-axis: max. 100 m/min
B-axis: max. 90 rpm
C-axis: max. 90 rpm

Accuracy
Smallest programmable increment: 0.001 mm
Position scatter linear axes X/Y/Z: max. 0.03 mm
Position scatter rotary axes B/C: max. 0.005°
Position deviation linear axes X/Y/Z: max. 0.08 mm
Position deviation rotary axes B/C: max. 0.015°

MACHINE DETAILS

Control and Data Processing
Control model: Simatic IPC627
Hard disk capacity: 60 GB
Color monitor: 12" TFT
Network speed: 100 Mbit/s
Modem: 56 kBaud/s

Pneumatics and Cutting Gas
Connection pressure: min. 6 bar
Connection pressure: max. 14 bar
Compressed air consumption (machine): approx. 30 Nm³/h
Short-term compressed air consumption: max. 40 Nm³/h
Cutting gas working pressure: max. 20 bar

Electrical Connection
Main machine: 47.0 kVA
Laser unit TruDisk 3001: 19.5 kVA
Laser unit TruDisk 4001: 27 kVA
Chiller TruDisk 3001: 9 kVA
Chiller TruDisk 4001: 12 kVA

Operating hours: 97,817 h

EQUIPMENT
Hard drive with RAID controller
USB interface
Ethernet network connection
RJ-45 plug
Support for ET BEUI, TCP/IP, Novell servers, and NTFS file system
Solid-state laser of the TruDisk series
High-speed rotary changer with fixturing technology and control
Scrap conveyor for continuous removal of cut parts and leftover grids