Laser cutting machine

TRUMPF TruLaser 5040

TRUMPF TruLaser 5040 6kW Laser, manufactured in 2012 in Germany by TRUMPF Maschinen Grüsch AG. The machine has been continuously serviced, upgraded, and maintained throughout its entire operation period.
Lodpfx Afex Nil Ispohr

The TRUMPF TruLaser 5040 (L18) laser cutting machine is designed for precise cutting of sheet metal made from materials such as steel, aluminum, copper, and brass. Laser cutting is performed using a stable 6 kW laser beam generated by a high-efficiency resonator. A range of additional systems streamline the machining process while enhancing cutting quality.

The entire cutting process is fully automated, thanks to the automatic pallet changer system. This system enables simultaneous loading and unloading of workpieces during operation, thus increasing productivity and minimizing machine downtime. The TruLaser 5040 is offered with extensive equipment, including additional cutting heads and an advanced CNC controller with many useful features.

In September 2022, the complete set of quartz tubes, all internal optics, and the lamp were replaced. The external optics were cleaned and calibrated in September 2025. Filters and oils were changed according to TRUMPF’s recommendations. Once a year, the water was changed along with flushing the CU and AL circuits. All these procedures are documented with proper service reports. Both original lenses for both heads and an optics case are supplied with the machine.

Technical specifications of the TRUMPF TruLaser 5040 laser cutting machine:

- Laser power: 6 kW
- Travel (X/Y/Z axes): 4000/2000/115 mm
- Maximum cutting thickness (mild steel): 25 mm
- Maximum cutting thickness (stainless steel): 25 mm
- Maximum cutting thickness (aluminum): 25 mm
- Maximum cutting thickness (copper): 10 mm
- Maximum cutting thickness (brass): 10 mm
- Operating hours: 51,839 h
- Machine on-time: 79,497 h
- Compressed air connection: 7-10 bar
- Nitrogen (N2) supply: 30 bar
- Oxygen (O2) supply: 20 bar
- Connected load: 120 kVA
- Machine power supply: 400 V; 50 Hz

TRUMPF Laser Cutter Equipment:

- CNC control: TRUMPF
- Laser source: TRUMPF TruFlow 6000
- BrightLine system (improves quality of thick sheet cutting)
- FlyLine system (fast hole cutting in thin sheets without pre-piercing)
- PierceLine system (monitors and controls piercing process, reducing duration by up to 80%)
- 250 mm cutting head
- 175 mm cutting head
- Automatic pallet changer system
- Cutting with compressed air, nitrogen or oxygen
- Longitudinal conveyor belt

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.