Cross-cut saw Stromab TR500+Matrix 6000

Stromab TR500+Matrix 6000

Cutting capacity: 55x360, 80x340, 95x325, 125x295, 135x280 mm
Minimum work piece thickness mm.10
Working table tilted 8°

Cutting unit technical features:
Pneumatic upstroke saw TR500
Motor power 10 HP (7,5 kW), Volt 400/50 Hz.
TCT Blade dia.500 mm., F=30 Z=144 S=4,6
Cutting cycle speed: 4 seconds

Push feed system technical features:
PUSH FEED SYSTEM AVAILABLE LEFT AND RIGHT SIDE
Feeding by rack and pinion system and brushless motor
Positioning precision +/- 0,4 mm
Strong infeed motor for a packet weight of 80 kgs
Maximum push feed system speed 90 m/min
Pneumatic rising of the pusher at the end of the cutting cycle and overhead returning.

Data entry management:
12 inch TOUCH-SCREEN Controller (800x600 pixel)
USB Port
Ethernet Port
LINUX Operating system
Loading and save machine parameters via USB Port
Blsdpfxshw Ng Ie Afhjk
Cutting cycle (pattern) editing and entered directly on the controller
Transfer of cutting lists created by PC via USB or Ethernet Port

Working software:
Manual input of loading board length
Partial optimization without length reading of the board
Cutting cycle with 3 optimization options (Maximum length, Sequence and Board sequence)
N°1000 cutting lists made up of 11 sizes or one list of 10000 sizes in sequence

Package "OPTI": automatic board length detection and full optimization.
Piece length reading by photocell
Cutting cycle: with 6 optimizing criteria: (Longest length, Sequence, Board sequence, Volume, Minimum waste and Priority length)
Package "OPTI PLUS": total optimization with knots
and defects removal (OPTION NOT INSTALLED ON THE MACHINE)

Technical Description:
Package "OPTI PLUS": for knots and defects removal
Photocell for reading wood mapping knots and defects
Marking with fluorescent chalks/crayon (Note Ð Can only be ordered in combination with ZA250)

Pneumatic side clamp device

Program creating lists on PC in XML