Hydraulic briquetting press; for grinding sludge, metal chips, or similar materials, briquetting pre

RUF RBK 55/2500/120 S

Revolving briquetting press RUF type RBK 55/2500/120 S
Hydraulic pellet press or briquetting press
for grinding sludge, metal chips, or similar
No. 70002 Year of construction 2009
Briquette diameter 120 mm
Briquette length in the pre-compactor approx. 120 mm
Pressing force in the pre-compactor 30 tons at 260 bar
Briquette length in the main compactor approx. 80 mm
Pressing force of the main press cylinder 250 tons at 260 bar
Stroke size of the main press cylinder 120 mm
Pressing force of the counter-press cylinder 250 tons at 260 bar
Stroke size of the counterpress cylinder 15 mm
Piston diameter of the main press cylinder 350 mm
Press stroke Cycle time approx. 30 sec. for grinding sludge with low residual oil content
Hopper size of the screw conveyor 1000 x 600 mm
Hydraulic motor power 37 kW
Mains connection 400 Volt, 50 Hz, 45 kW
- Revolver with 5 stations for high material throughput
- Pre-compressor stage for pressing material into the turret disk
- 2 opposing main press cylinders with 120 mm and 15 mm stroke
- Ejection cylinder for ejecting the finished briquettes from the turret disk
- Infinitely variable adjustment of the hydraulic speed for each pressing stage
- was used for grinding sludge from metal processing
- Material hopper as hopper with screw conveyor
- the machine was completely overhauled at RUF in 2018
- a new SIEMENS Simatic touch panel was installed in 2020
- only a few operating hours after the overhaul
very good condition

Grinding sludge recycling
Iijdpfx Ashg Uz Ijcyoh
- great savings through cooling lubricant recovery
- Large savings in disposal costs due to the reduction in volume and weight of the grinding sludge
- Grinding sludge briquettes with a low residual oil content can possibly be classified as "non-hazardous waste".

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.