Shredder, pallet shredder

muetek MGZ 1030

Machine in preproduction
machine available

Advantages:
+ special rotor with reduced knife protrusion
+ Motor 22 kW
+ effective square knife

* for pallets: up to 10 pallets per hour * depending on the sieve and material. With smaller residual wood, significantly more.

Engine: 22 kW; 400 V - 50 Hz - 3 ph,
Sieve: 15/20 mm

hydraulically operated slide
Current screen perforation (15/20 mm) * can be exchanged
Extraction nozzle Ø 200 mm.
Feed opening 1000x1000 mm
Dimensions: 2000x1800x1645mm
Example image above: The color of the system may vary
Weight: 1920 kg.

Included as standard:
- Control cabinet with PLC control
- automatic star / delta start
Fgodpfodv Eu Hox Ahxjh
- fast hydraulics
- automobile. OFF when the rotor is idling
- Speed ​​70-90 rpm for high throughput
- cycle control to avoid idle times,
- performance-increasing step control of the hydraulic slide,
- Pertinax guides for hydraulic slides,
- vibration-damping machine feet,
- CE conform.

The following options are available at an additional cost:
- Additional row of knives + € 2,790
- segment bottom + € 6,890
(recommended for materials with a wall thickness thinner than 3 mm)
- Special K-rotor storage + € 3,480
If necessary, consider shredding plastic with sieves smaller than 15 mm or with a lot of fines. If the bearings are lubricated with grease every approx. 4 weeks in operation, this is not necessary)
- Raise the shredder by 30 cm (preparation for conveyor belt) + € 2.480 net
- Angled conveyor belt (discharge height approx. 220 cm) + € 12.980 net
- Overbelt magnet + € 5.980 net
- Control conveyor belt and overbelt magnet + € 2.750 net
(Start and stop synchronized with the hacker)
- Exhibition hopper 1500x1500 mm + € 3.480 net

Requirements for the raw material:
- The moisture content (atro) must be below 30%
- The loading must be free of metals and mineral impurities. This can result in damage to the tools and / or increased wear