Plasma cutting machine

Microstep Mastercut Eco Plus 3001.15

Microstep Mastercut Eco Plus 3001.15
Year of manufacture: 2017
Control system: IMSNC
Oxy-fuel cutting table: 3000 x 1500 mm
Extraction duct left / right
Plasma source: Kjellberg HiFocus 161i, adjustable 10 - 160 A
Crjdpjy Nd Hyofx Ai Doh

Power source HiFocus 161i PLUS
• Flexible adaptation of the cutting process to required conditions thanks to soft-switch inverter and microprocessor control
• Optimal process control with ultra-fast regulation of cutting current
• Process monitoring for torch cooling, ignition time, pilot arc time, short circuit time during torch ignition, and power source
• Operating status and error display via LED and screen
• Analog and serial interfaces for adaptation to CNC controllers
• Infinitely adjustable cutting current from 10 - 160 A and during marking from 5 - 25 A
• Optimal piercing through infinitely variable delay time for the main arc and adjustable current rise
• Adjustable current reduction for cornering, start, and end signals of the guidance system
• Automatic display of the preset cutting current
• Serial data transmission for PC-based diagnostics

Plasma cutting technology: Contour Cut
• Further development of HiFocus technology for mild steel
• Optimized for cutting fine internal and external contours
• High cutting quality and contour accuracy
• Holes with angular deviations according to DIN EN ISO 9013 range 2-4
• Minimal angular deviations and smooth cut surfaces
• Excellent repeatability and dimensional accuracy
• No tedious post-processing – high productivity and low costs
• No additional equipment, software, or new consumables required
• Standard equipment

Plasma torch PerCut 200/210
• PerCut 200 plasma machine torch for standard applications and high-precision bevel cutting
• Quick-change PerCut 210 torch with threaded lock for quick and convenient tool swapping
• Special torches available for special applications
• Higher cutting speeds reduce cost per meter
• Long service life of consumables conserves resources
• Narrower kerf means fewer emissions and less waste
• Significantly lower gas consumption compared to competitors thanks to efficient liquid cooling up to the nozzle tip
• Lower noise levels due to reduced gas consumption
• Bevel cutting up to 50 degrees with standard consumables
• Cutting and marking possible with the same consumables

Power source HiFocus 161i
Power supply: 400 V; 3 Ph; 50 Hz
Max. power input: 28 kVA (100% duty cycle)
Main fuse, slow-blow: 50 A
Protection class: IP22
Open circuit voltage: 330 V
Cutting current: 10 – 160 A (100% duty cycle)
Marking current: 5 – 25 A (100% duty cycle)
Cutting range:
Max. 50 mm
Recommended: 0.5 – 38 mm
Max. piercing thickness: 30 mm
Weight: 206 kg

Plasma machine torch PerCut 200
Quick-change torch PerCut 210
Clamping diameter: 50.8 mm
Plasma gases: O2, N2, Ar/H2
Marking gases: Ar
Swirl gases: O2, N2, Air, N2/H2 (F5)

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.