Cantilever rack

Kragarmregal doppelseitig Höhe 3.500 mm Tiefe je Seite 1.200 mm / Länge 4.000 mm

Cantilever rack double-sided used: Hot-dip galvanized screw system

Scope of delivery:

4 double-sided shelf uprights, height 3,500 mm with foot parts each 1,200 mm

24 cantilevers with 1,200 mm depth, standard

Including longitudinal and diagonal braces for 1,300 mm axle spacing

Incl. fastening material (without ground anchors)

- (*Delivery time approx. 1 week)

- (*No damaged parts!)
- (*Reorder spare parts and extension possible at any time)

- (*Also available in larger quantities: 20 uprights in stock)

Detailed description:

- Stable steel construction made of IPE profiles
- Surface of all components hot-dip galvanized
- Load capacity per upright side 2,250 kg
- Load capacity per cantilever arm 750 kg
- Cantilever arms height adjustable in 100 mm increments
- 6 screwable cantilevers per upright and 2 foot parts with a depth of 1,200 mm, standard
= 4 storage levels one above the other per stand side
- Including longitudinal and diagonal braces for 1,300 mm spacing
- Shelf length 4,000 mm
- Including fastening material (without ground anchors)
- With assembly instructions and load plates C4 in accordance with DIN standard
- Expert advice by telephone
- Made in Germany
- Short delivery time
- Collection on site possible

Our cantilever racks are produced exclusively in Germany.

We offer reliable freight with registration before delivery.

Pgsdemkixwepfx Adzsl
The material is sensibly packed to enable easy unloading.

When installed outdoors, the load-bearing capacity is reduced by the wind and snow load.

The subsurface must be made of concrete, level and dowel-capable and must be able to bear the loads. The condition of the soil and load-bearing capacity as well as any official permits required must be checked and guaranteed by the customer.

The shelf supports must be anchored to the floor on site; anchoring to the wall is not necessary and not recommended.
According to the trade association, it is recommended that the shelf supports on the top storage level have a projection of at least 500 mm above the top edge of the supports.

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.