Hydraulic press

Hidrogarne MV-600E/NC

The MV-600E/NC four-column hydraulic press belongs to the M/NC series and is custom-designed to achieve greater precision and capacity, specifically manufactured for stamping, deep drawing, punching, and deburring tasks.


Power tn 600
Motor Power 40 HP a 440 Vca / 60hz
Working Speed mm/s 5
Approach Speed mm/s 15
Return Speed mm/s 18
Piston Stroke mm 1.015 mm - (40”)
Guide Diameter mm 200
Table Usable Area mm 990 x 890 x 130
(39” x 35” x 5”)
Between Columns mm 990 x 370
Vertical Clearance mm 1.625 - (64”)
Working Height mm 990 - (39”)
Lower Hydraulic Knockout Tn 80
Knjdpfxewpggio Afpjf
Lower Knockout Stroke mm 406.4 - (16”)
Upper Hydraulic Knockout Tn 80
Upper Knockout Stroke mm 406.4 - (16”)
Total Frontal mm 1.850
Total Lateral mm 1.700
Total Height mm 4.500
Weight Kg. 23.000 Kg. approx.

Equipped with a top and bottom table made of C45E steel, machined with DIN-650 slots, and a removable upper counter-table of 990 x 890 x 130 mm for die holders with “T” slots. We ensure minimal friction in the vertical movement of the top table through the installation of maintenance-free bimetallic bushings, with perfect parallelism achieved by four chromed and ground cylindrical columns.

It uses an optimized hydraulic system with a pressure of 320 Bar, ensuring prolonged durability and reliability in its performance.

It meets and satisfies all essential safety and health requirements according to CE regulations.

STRUCTURE AND TABLES
• Consists of three electrowelded blocks made exclusively of S355JR steel.
• Stabilized and machined at the end of the welding process to ensure perfect parallelism and precision.
• Calculated and designed using finite element software.
• Incorporates a SIEMENS SIMATIC S7 1200 PLC and a 7” HMI KTP-700 touch panel. This allows programming of the power, cylinder stroke, and speeds, with a storage capacity of 300 memories for different work cycles.

CYLINDER AND HYDRAULIC GROUP
• Double-acting cylinder with lapped sleeve, chromed piston, and maintenance-free anti-wear guides.
• Motorized hydraulic group with two speeds and automatic disconnection of fast speed. High-pressure pump and 10-micron return filter. Includes cylinder decompression valve, directional valve, and safety valve. A pressure switch located on the side allows the most appropriate pressure setting for each type of work.
• Glycerin manometer with reading in tons.

ELECTRICAL INSTALLATION AND SAFETY
• The electrical panel incorporates a selector to choose manual, semi-automatic, or automatic operation modes, and another selector for fast or slow speed operation.
• Equipped with a PLC to internally assist with maneuvers and decompression time.
• Operation is carried out using a low-voltage electric two-hand button panel.
• Electrical and hydraulic maneuvers are redundant and self-controlled, incorporating an additional safety block and self-control devices for maneuvering and safety. Includes verification and certification of proper operation and safety distance for photocells.
• For safety, category IV photoelectric barriers are incorporated in the front work area, two fixed side protections, and a movable protection with a magnetic disconnection detector at the rear.
• Machine equipped with an IXON system for online communication in case of faults or reprogramming.
• Ladder with upper walkway for repair access (scaffold).