Lowbed

Fliegl ZTS 200 Mähdrescher

Custom-made transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are customized according to customer specifications.

Further information
Chassis
Steel welded construction, with slight preload in the center, turntable with robust ball bearing race, support wedges with holder, quarter-shell fenders in front of and behind each axle.
Tie-down points, low-bed trailer:
above the front axle:
2 pairs of ring tie-down points, each 5 tons, at the front on the outrigger
low-bed:
4 pairs of tie-down points, each 6 tons, on the sides in the low-bed
5 pairs of tie-down points, each 5 tons, between the longitudinal beams
Tow hitch, trailer turntable
Tow fork with tested 40 mm drawbar eye, mechanically adjustable in length by 6 x 100 mm and lockable
Bsdpfx Aksi Ri N Aeajwu
(Tow fork length 1,700 - 2,300 mm)
Axles + Suspension
BPW drum brake axles, each 10 tons axle load, spring plates. Axle endurance brake test for 105 km/h, rear axle can be manually removed.
Air suspension with raising & lowering valve
Wheels and Tires
235 / 75 R 17.5, from leading manufacturers, steel rims in twin arrangement, factory silver
Braking system
2-line compressed air brake system, spring-loaded parking brake, 2 tamper-proof coupling heads at the front, with connecting lines to the towing vehicle, EBS, electronic brake system with EBS plug at the front, with connecting cable
Note: The trailer may only be pulled by towing vehicles that guarantee the effectiveness of the ABS!
Electrical system
24 Volt, multi-chamber lights, yellow LED lighting on the sides, 2 white position lights at the front, 2 white/red marker lights at the rear, rotating beacon with holder, switched via parking lights (light can be removed), 2 pairs of warning signs, double LED illuminated and extendable to 3,300 mm, removable with plug, 2 x 7-pole tamper-proof plugs at the front, with connecting cable, 1 x 7-pole agricultural plug, voltage converter 12/24 Volt (only for electrical system, not for ABS/EBS)
Floor
Steel/diamond plate floor on the outrigger, perforated sheet covering between the longitudinal and transverse beams. Axle cover is not designed to be driven over, widening to 3,000 or 3,300 mm is possible.
Operating instructions
Note! A special permit is required for a 10,000 kg axle load. The permit must be applied for separately in each federal state; the legislator does not have to give a guarantee for 20 tons GVW. Customer risk.
A special permit is required if the overall length of the train exceeds 18,750 mm. Observe country-specific registration regulations.
The specified total weight is technically possible; depending on the cargo, the total weight may not be reached while complying with the permissible axle/support and saddle loads.
Observe the BO circle!!!
Registration / Signs
Country of registration: Germany, with Dekra inspection and certificate (according to §13 EG - FGV), prepared for single-row license plate holder, warning sign according to ECE - 70, contour marking with reflective strips according to ECE R 048
Painting
Frame at the front hot-dip galvanized incl. passivation, frame at the rear RAL 9006 silver, tow fork KTL black
Note: Archive images!

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.