Electric press brake

Durma AD-ES 1240

The DA-69T control offers both 2D and 3D programming, which includes automatic calculation of the bending sequence and collision detection. The entire 3D machine setup includes multiple tool stations and provides immediate feedback on product feasibility and handling.
DA-69T features:
- 3D- and 2D- graphical touch screen programming mode
- 3D representation in simulation and production
- 17-inch TFT colour display with high resolution
- Complete Windows Application Suite
- Compatible with Delem Modusys (module scalability and adaptivity) - USB, peripheral interface
- Open system architecture
Nsdpfx Aed Sak Sen Tewf
- Sensor Bending and correction interface
- Profile-T3D offline software
- great contribution to environmental protection, climate change and the greenhouse effect will thank us, the next generation will thank us too!

- Fully electronic drive
- Up to 30% higher productivity
- Up to 50% energy savings through Start-Stop technology
- Faster than hydraulic press brake
- Reduced operating costs
- Much lower service and spare parts costs (the electric press brake is technically much simpler and almost maintenance-free)
- No harmful oil
- quiet - efficient - independent of Hyd. Oil - Low noise operation
- relaxed and stress-free bending
- Complete work area
- Touchscreen operation

Machine dimensions:
( L x W x H ): 2.150 mm x 1.650 mm x 2800 mm
Technical details:
bending length: 1.250mm
Free stand passage: 1.300 mm
Press

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.