CNC turning and milling center

DMG GILDEMEISTER TWIN 102

DMG GILDEMEISTER TWIN 102 CNC Turning and Milling Center

- Recorded spindle hours: 43,558
- Spindle speed range: 3,200/5,000 rpm
- Swing diameter: 270 mm
Gsdpfx Aoyaqgyoc Dobp
- Spindle distance: 900 mm
- X1 axis travel: 290 mm
- Z1 axis travel: 650 mm
- X2 axis travel: 180 mm
- Z2 axis travel: 650 mm
- Y1 axis travel: ±40 mm
- Z3 axis travel: 670 mm
- X3 axis travel: 175 mm
- Max. bar diameter: 100/104 mm
- Number of driven tools per tool turret: 12

- Including chip conveyor, with 2 tool turrets (each with 12 tool stations), main and counter spindles, as well as foot switches

Attention, the machine has the following defects:
- The B-axis is defective (mounted on turret 1)
- Guideways and drives show age-related wear
- X2 axis (guide rails) runs slightly out of alignment by approximately 0.03 mm (should be re-measured)
- Occasionally, axis reference value setting in the control system fails
- The hydraulic pump was replaced after a failure and is now installed externally as a standalone unit

FCA D-58256 Ennepetal, loaded on truck at a mutually agreed date at the end of February 2026.

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.