Injection molding machine

Demag Ergotech IntElect 150/520-610

Demag IntElect 150/520-610

General Information

Year of manufacture: 2007
Weight: 6,900 kg
Dimensions (L × W × H): 5.5 × 1.5 × 2.1 (2.3) m
Control system: NC4
Operating hours: 26,500 Bh

Clamping Unit

Clamping system: 150/...
Clamping force: 150 t
Platen dimensions (H × V): 770 × 770 mm
Tie bar distance (H × V): 520 × 520 mm
Mould height (min.–max.): 275 mm (max. increased)
Max. distance between platens: 1,180 mm
Ejector stroke: 125 mm
Ejector force: 35 kN
Isdpfjxn N H Tjx Acystn

Injection Unit

Injection unit type: …/610
Screw diameter: 45 mm
Screw L/D ratio: 20
Shot volume: 305 cm³
Shot weight: 270 g
Specific injection pressure: 2,050 bar
Wear-resistant screw; bimetallic barrel, standard L:D
Check valve (RSP), 3-piece, ring type
Increased injection speed: 300 mm/s

Additional Equipment

Increased mould installation height (min. unchanged, max. increased)
Electrical/hydraulic interface for connecting 2 hydraulic cores on the moving mould platen via a separate hydraulic unit
Offer valid for the injection moulding machine only

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.