CNC working center with edging

Biesse Rover A Edge 1632

Numerical Control BH 660 with BIESSE BSolid software
bEdge module for edge management
bSolid surface design
Sophia - IoT Connection
Office control
Working range on X-axis mm 3228
Working range on Y axis mm 1580
Working range on Z axis mm 200 with H74 mm suction cups
Working range on Z axis mm 245 with H29 mm suction cups
No. 8 adjustable ATS panel support bars
Installation of the pneumatic lock divided into two zones in Y
No. 6 Pneumatic Bakelite bars for panel lifting
No. 3 adjustable suction cups for bar
Set-Up Assistant for Suction Cups
No. 1 electrospindle (pantograph) with 4 axes, automatic tool change, KW 13 (HP 17.4) motor, cooling
liquid, HSK cone attachment, 20000 RPM
Automatic tool change with 16 positions on the X-axis of the carriage
Drilling tesa BH17 independent spindles arranged as follows:
No. 5 independent spindles for vertical drilling in the "X" direction
No. 5 independent spindles for vertical drilling in the "Y" direction
No. 4 spindles for horizontal drilling in the "X" direction
No. 2 spindles for horizontal drilling in "Y" direction
No. 1 blade integrated into the drilling head diam 120 mm (useful cut 25 mm)
GU60L gluing unit for EVA glue with pre-melter - edge pressure system with double rubber roller for spokes
maximum internal 30 mm and edge joint sensor - 500 ml glue pot installed on the glue roller - lamp
edge heating - edge feed system - edge cutting system - possibility of
Introduction of the manual edge
Plastic edge thickness from 0.4 to 3 mm
Wood edge thickness from 0.4 to 2 mm
Laminated edge thickness from 0.4 to 1.2 mm
Lhodpfx Aougpwnsavjn
Maximum edge width 65 mm
Workpiece thickness from 10 to 60 mm
Minimum internal radius workable with 30 mm edging
Maximum external radius for edging, proportionate to the thickness and stiffness of the edge:
* 10 mm with edge up to 1 mm thick
* 20mm with 2mm thick edge
* 30mm with 3mm thick edge
Minimum dimensions of the edging panel 300 x 300 mm
Minimum internal diameter for edging: 350 mm with plastic edges less than 1 mm thick and with panel
maximum thickness 18 mm
2-position edge storage unit positioned inside the protective casings for edges with maximum thickness
65 mm
Finishing aggregate cleaning station with automatic dispensing of special cleaning liquids and with a
cleaning cycle
No. 1 aggregate for edge trimming / rounding
No. 1 EF60A combi aggregate trimmer / edge scraper / glue scraper
Perimeter protection grids
Chip evacuation system with motorized belt
Liquid cooling system
Automatic lubrication system
No. 1 vacuum pump of 250 m3/h
TECHNICAL DETAILS TO BE CONFIRMED