Laser cutting machine

TRUMPF TruLaserCell 8030 (L45)

Working range:
X = 3000 mm / Y = 1300 mm / Z = 600 mm
Ijdpfxorb Dg Ne Afpjtr
B = +/- 135°
C = n x 360°
Standard configuration:
- Fixed pendant control panel
- Teach panel
- Teach software
- TruDisk 3001 solid-state laser
- Air cooler Cooling and pilot laser (switch)
- LLK with 30 m
- Prepared for laser cutting
- Cutting gas: nitrogen
- Dynamic cutting optics with f = 150 mm
- Magnetic coupling
- FocusLine
- Control: Siemens Sinumerik 840 D (open control on PC basis)
- Network card

Special configuration:
- MDE interface
- FastLine Cell
- ObserveLine
- Rotation changer D = 4000 mm incl. rear step protection
- Scrap conveyor belt
- 4 x configurable control interface
- Valve terminal for 8 pneumatic clamps per side
- 2 x loading status light for rotation changer
- 3 x horizontal pre-crushing interface
- Protective cabin for rotation changer incl. light curtain, protective grille and signal light
- Status lights below and above
- Video surveillance with camera and monitor holder

- incl. extraction system

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.