TEKA Airtech welding fume extractor

TEKA AirTech P18

Dust extraction, filtration, welding fume extraction, self-cleaning cartridge filter, pneumatic, vacuum-based TEKA AIRTECH P18.

The main areas of application for these systems are industrial plants/welding shops where it is not possible to implement point extraction or where point extraction is not sufficient to maintain clean air in the workshop.
Laterally mounted ducts with a pollution collection point draw in contaminated air and lead it to the filtration section.
Here, pollutants in the form of fine particles accumulate on the surface of the cartridge filter.
A compressed air pulse is applied to clean the cartridge filters automatically at the required intervals. After the compressed air pulse, the particles collected on the filter surface detach and fall into the dust collection tank.
The cleaned air returns to the work area through individually adjustable long-range nozzles. At the same time, the outlet of the cleaned air directs the contaminated air in the workshop towards the extraction ducts.

The filter is cleaned by a microprocessor controller with compressed air pulses during operation, resulting in high device efficiency.
Low compressed air consumption thanks to the "Power-Spray" system.

The AIRTECH series of devices is certified by IFA according to EN ISO 15012-1 or DIN EN ISO 21904-1/-2 and approved for welding fume class W3 as a stationary, local welding fume extraction unit.

Parameters:

Capacity - 18,000 m3/h
Bledpfo Ahm Iisx Apnop
Motor power - 11 kW
Vacuum - 2250 Pa
Filtration area - 324 m2 (9 filter cartridges of 36 m2 each)
Fan in a sound-absorbing housing
Control cabinet with electrical documentation
Noise level - 72 dB

Dimensions:
Height - 5.00 m
Base width - 1.44 m x 1.44 m
Width with outlet ducts - 8.5 m
Total weight approximately 2400 kg

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.