GDI-6000 Petrol Injector Test Device

TECHNOMAKS GDI-6000

It features a specially designed ergonomic structure. (The cabinet section also serves as a cargo carrying box.)

Aluminum body, test rail, and bottle holder; flexible, custom test tubes resistant to hot and cold weather conditions, 6X150 (mg).

From 1 injector to 6 injectors, with easy-to-connect fittings, injectors can be connected in a short time. Thanks to the injector drip reservoir, you can perform detailed spray pattern detection. Each test lasts a maximum of 90 seconds.

With a 200 bar system (Electronic Measurement) specially designed for the GDI-6000, pressures are measured clearly. The GDI-6000 reaches a maximum of 200 bar. Thanks to this pressure, drip tests can be observed very clearly. With the ability to print receipts, you can provide test results to service centers and organizations that require them.

Thanks to the DATABASE, the (mg) values that more than 6000 different types of injectors should deliver can be seen on the 7.0-inch touch screen.
Dodpfsz D H Dfsx Acrscp

Thanks to the NEW-ENJ+ MODE, you can create and save injectors and injection parameters that are not found in the DATABASE.

Thanks to the OHM-TEST MODE, you can measure the injector (OHM test) values.

AUTO-1: Low speed (4000 RPM)
AUTO-2: Medium speed (5000 RPM)
AUTO-3: High speed (7000 RPM)

DRIP TEST: Thanks to the Leaking Out mode, you can perform injector drip (leakage) tests clearly under pressure.

Thanks to the MANUAL MODE, you can perform the desired RPM, PULSE, and TIMER tests with the RPM+ PULSE+ and TIMER+ settings.

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.