Machining center

Röders RP 800

Portal machining center for HSC milling

The machine works in a Röders RCM automation system. It can therefore be integrated into an automated production system.

Technical data
- Travel ranges: X 800 mm, Y 600 mm, Z 400 mm
- Drive power: 17 kW
- Speed: 36,000 rpm - Fischer motor spindle
- Spindle mount: HSK E50
- Feed rate: up to 60 m/min.

Work table
- Dimensions 900 mm x 700 mm
- Max. workpiece weight 800 kg

Control
- Röders HSC RMS6, including software for:
milling simulation and for cutting out machining
- Electronic hand control panel and mouse
- Ethernet interface integrated in Windows NT
- Remote maintenance of the RSM 6 machine control

Machine structure
- Portal version with temperature stabilization of the machine frame

Tool changer
- 30 stations with collision monitoring

Equipment
- Cooling unit for milling spindle
- Infrared measuring probe for automatic:
tool length correction, diameter measurement and tool breakage monitoring
- Microjet spray cooling and lubricator
- Fixed bearings and spindle nuts water-cooled
- Fully protected cabin (crane loading possible)
- Connection for the work area extraction
- 2 pcs. Screw chip conveyor
- Workpiece cleaning via separate air nozzles

Machine data
- Space requirement (without service areas!) LxWxH approx. 3,100 mm x 3,000 mm x 3,200 mm
- Weight approx. 13,000 kg
- Connected load 400V, 50/60 Hz, 3 phases

The machining center is in good condition. Maintenance and repair work was carried out regularly.
A viewing with power and chips is possible by appointment.
All tools and operating materials shown in the photos are not included in the scope of delivery of the machine.
Technical changes and errors reserved.
Codpfxsvri Nmo Acrori

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.