Cut-to-length and slitting line

OSTERBERGER FLQ1250.1,2-industrial

PLC-controlled, compact slitting and cross-cutting line for thin sheet metal, designed for industrial cutting, and boasting very high quality.

PLC control with touchscreen – the quantity and section length are programmed.

Ndodpfx Ansz Ei D Rsksb
Maximum sheet width: 1,250 mm
Cutting performance for sheet thicknesses ranging from 0.5 mm to 1.2 mm, using SJ235JR steel sheet with a tensile strength of 360 N/mm², with three sets of slitting knife pairs.
The slitting unit is an autonomous module.
For quick adjustment of the rotary knife pairs, the slitting unit can be easily pulled out or pushed in. Alignment unit with eight hardened and ground alignment rollers.
Adjustment of the lower alignment rollers is motorized.
Rubber-coated feed rollers – this allows for the processing of coated sheets as well.
Slitting shear with 3 to 5 knife pairs.
Smallest strip width: 200 mm
Maximum cutting speed: 20 m/min

Very fast, mechanically guided cross-cutting shear for absolutely clean, burr-free cuts.

Voltage: 3 x 400 volts – fuse rating: 25 amps – total drive power: 5 kW
Dimensions, excluding the outfeed table, approximately 3 m x 1.9 m x H 1.8 m
Weight, approximately 2,800 kg

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.