Magnetabscheider

mütek HAWK-EYE

*Only the neodymium overbelt magnet is offered, not the conveyor belt underneath.

*Neodymium magnets are among the strongest magnets in the world. They have an extreme pulling power and cannot be compared to ferrite magnets.

Extremely high degree of separation, depending on the bulk height and the starting material.

Probably the most compact overband magnet on the market.
The competition often uses the less powerful ferrite magnets to save costs.

dimensions approx.
Length: 104cm
Width: 22cm
Height: 28 cm (at the motor)

*Without controller
Surcharge for simple manual start/stop control + 495 €

A high-performance industrial neodymium magnet is installed.
High-performance neodymium magnet approx. 600x68x36.5 mm
* So nails are attracted to a length of 600 mm and thrown off to the side, in the area that is no longer magnetic.

This overbelt magnet should be mounted approx. 5 - 9 cm above the material flow. *Assembly/suspension on site

Ideal for separating nails from wood chips.
Optionally also in a single-shaft shredder that is sucked off

Requirements:
*Your belt width or useful width inside (of the existing conveyor belt) should ideally be narrower than 55 cm
Tedpsdubpuofx Akaoc
*Suitable for separating nails from material flows that are less than 12 mm high and with a chip length of less than 25 mm.

-----
Optional at extra charge:
Cross and ascending belt demonstrators from € 7,995 net