Turntable drawbar trailer

Fliegl ZPS 180 Jumbo-Z Drehschemel Anhänger

- Attention: archive photos!
#Chassis turntable drawbar trailer
Podpfxjz Eg N Ds Anksrb
- Outer frame slightly inclined with "Load-Lock" profile for hooking in lashing straps
- 9 pairs of additional lashing eyes recessed in the outer frame, 5 t each
- Wheel chocks with holder
- Aluminium side guards
- Steel underrun protection
- Quarter mudguards ahead of and behind each axle
- with anti-spray mud flaps
- 1 row of lashing/stake rails recessed lengthwise in the centre of the floor (from end of front cross member to start of rear cross member), approx. 80/110 mm high, with cut-outs at top and bottom for Fliegl plug-in stakes 80 x 80 mm; at the bottom an angle plate as stop, half open downwards, for inserting stakes 80 x 80 mm
- 3 lashing/stake rails recessed crosswise in the floor (cut-outs approx. 63 x 63 mm) across the full width up to the outer frame, approx. 80/110 mm high, with cut-out
- 1 aluminium storage box with stainless steel lid, w=600/h=400/d=500 mm, lockable
- Container locking: 2 pairs of locking cut-outs recessed in the floor for 1 x 20 ft container, 2 pairs of container locking adapters
#Drawbar turntable trailer
- Drawbar with certified 40 mm drawbar eye, mechanically length-adjustable by 6 x 100 mm and lockable
- Parking sockets for electrics/EBS and air couplings on drawbar
#Axles + suspension
- SAF drum brake axles
- One axle check rope per axle for turning or loading the trailer
- Air suspension with raise & lower valve, front and rear separately operable
#Wheels and tyres
- 235/75 R 17.5"
- make at manufacturer's choice
- Steel rims in twin configuration, factory silver
- TPMS tyre pressure monitoring system acc. to ECE R 141, display in towing vehicle via EBS
#Braking system
- 2-line compressed-air braking system
- Spring-brake parking brake
- Duomatic coupling at front, with connecting line to the truck
- EBS electronic braking system with EBS socket at front, detachable coiled cable
- Attention: the trailer may only be towed by towing vehicles which ensure the effectiveness of the ABS!
- Drawbar lock release button and double release valve mounted at front turntable
- Vehicle stability system
- Axle load detection via EBS CAN bus signal, for display in the driver's cab
#Floor
- Floor for forklift with gross weight up to 4 900 kg
- Film-faced plywood approx. 30 mm thick
- Premium floor sealing, joints sealed all round
#Paintwork
- Frame hot-dip galvanised incl. passivation
- 15-year warranty against rust-through
- Currently without headboard/dropsides and folding stakes, but available as an option
#Headboard/front corner stakes
- 25 mm aluminium hollow profile, 1 350 mm high, steel front corner stakes, transversely mounted
- Headboard additionally lined inside with 1250 mm high film-faced plywood
#Dropsides
- 25 mm aluminium hollow profile, 600 mm high, fold-down and removable
- without tarpaulin groove
- Dropsides with Kinnegrip locks, also at front on headboard
#Centre stakes
- 2 pairs of folding stakes at dropside height, fold-down and removable, make Kinnegrip (flush or nearly flush with dropsides where possible)
#Rear wall/rear corner stakes
- 1 pair of folding stakes at dropside height, fold-down and removable, make Kinnegrip
- 25 mm aluminium hollow profile, 600 mm high, fold-down and removable, with folding step inside
- Attention: archive photos!