Lowbed

Fliegl Tiefladeanhänger DTL 300 P Agrar 5,9m

Tailor-made transport solution
Configure your Fliegl vehicle to your requirements. The vehicle shown is an example. Production and specification are customised to customer requirements.
#Low Loader Drawbar Trailer Chassis
Welded steel construction
Turntable with heavy-duty ball race
Folding rear support legs
Wheel chocks with holders
Full-width rear mudflap
1 plastic toolbox
Preparation for extensions to 3,000 mm (holes in outer frame with covers, not in rear bevel)
#Lashing Points Low Loader
1 pair of recessed 10 t lashing cut-outs in front gooseneck side members
7 pairs of recessed 10 t lashing points in top and side outer frame
1 on front gooseneck
5 in low bed
1 in rear bevel
12 pairs of 5 t lashing holes in outer frame (for load straps)
5 on gooseneck, 6 in low bed and 1 in rear bevel
#Drawbar Equipment
Drawbar with certified 40 mm towing eye
Spring-assisted drawbar height adjustment
#Axles + Suspension
Drum brake axles, manufacturer's choice
"Achsen-/Fahrwerk laservermessen" reduces tyre wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bushes and mechanical axle load equaliser
#Wheels and Tyres
Nedpfx Ajznyrmjbmjlf
235/75 R17.5
Manufacturer's choice
Twin steel wheels, factory silver
#Braking System
Twin-line air brake system
Spring parking brake
2 non-interchangeable front coupling heads with connecting lines to towing vehicle
Connecting lines extended by approx. 60 cm
Without ABS, with mechanical ALB, max. 60 km/h approval
#Electrical System
12 V multi-chamber lights, without yellow side LED lights, with side reflectors
2 front white position lights
2 rear white/red outline marker lights
1 x 7-pin 12 V front plug with connecting cable, extended by approx. 60 cm
1 removable LED beacon with bracket, switched via side lights
#Floor
Front gooseneck with steel chequer plate
Recessed storage box in transition to gooseneck
70 mm softwood floor, steel chequer plate in wheel arch area
Rear bevel with 70 mm softwood floor
Low loader deck incl. rear bevel: 5,900 mm
#Loading Ramps
Steel ramps, 2,800 mm long, 750 mm wide, laterally adjustable
Timber-covered (steel chequer plate at ramp tips)
Hydraulic operation via PTO with flow control, left-hand side operation in direction of travel
Hydraulic connection with SVK plug NW 10/3 incl. connecting hose
#Registration / Plates
Registration country: Germany
With DEKRA inspection and approval report for max. 60 km/h registration, agricultural towing vehicle
Prepared for two-line number plate holder
Without contour marking / reflective strips according to ECE R 048
#Paint Finish
Chassis hot-dip galvanised incl. passivation
"15 Jahre Gewährleistung gegen Durchrostung"
Drawbar galvanised or black, manufacturer's choice
Loading ramps hot-dip galvanised