Open semitrailer

Fliegl SDS 390 Plateau mit Verriegelung+Rungen

Customized Transport Solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are customized to individual customer requirements.

Chassis, Fifth Wheel, and Transport
Fine-grained steel welded construction, fifth wheel plate with interchangeable 2" kingpin, mounting position for warning signs at the rear, outer frame with "Load-Lock profile" for lashing straps, 24-ton capacity, two-speed landing gear, single-sided operation, lashing eyes, yellow marked, 2 of which are located at the rear as towing eyes, container locking: 4 pairs of container locking mechanisms embedded in the floor for 2 x 20 ft or 1 x 40 ft containers, pocket recesses embedded in the outer frame, 80 x 80 mm internal dimensions, pocket recesses embedded in the center of the floor, 80 x 80 mm internal dimensions, plug-in crossbars B=80/ D=80/ L=1200 mm, hot-dip galvanized, lashing eyelets embedded in the outer frame, 5 tons each, 2 storage boxes b= approx. 1230 / h= approx. 450 mm, closed and mounted across the entire width in front of the axles, replacing side impact protection, front locking mechanism can be inserted as a pin, lashing/crossbar rails embedded transversely in the floor across the entire width to the outer frame, approx. 100 mm high, with 20 mm round steel rails, top and bottom, distance from top to bottom approx. 60 mm (of the round steel), with angle sheet at the bottom as a closure, open halfway downwards for lashing and inserting crossbars 80 x 80 mm, storage compartment for warning signs, open, as technically possible.
Axles and Suspension
SAF disc brake axles, "axles/chassis laser-measured" to reduce tire wear and fuel consumption, air suspension, 1st axle automatic lift axle, including forced lowering and start-up assistance, operation "3x brake", 2 driving heights, can be switched over via hand knob:
1 x for saddle height 1120 mm
1 x for saddle height 1200 mm
Braking System
2-line compressed air braking system, color-coded lines for easy maintenance, spring-loaded parking brake, 2 non-interchangeable coupling heads at the front, EBS, electronic braking system with EBS socket at the front, with lifting and lowering valve, vehicle - driving stability system
Wheels and Tires
385/65 R 22.5", steel rims, factory silver
Electrical System
24 Volt, 4 x 3-chamber lights, yellow LED lighting on the sides
2 white position lights at the front in LED
2 white/red marker lights at the rear in LED
2 x 7-pin and 1 x 15-pin non-interchangeable sockets at the front, without connection cable
Rotating beacon with holder, switched via parking light (light can be removed)
2 pairs of warning signs double LED illuminated, extendable to 4500 mm and removable with plug.
With additional holder at the rear
Additional 7-pin socket (according to ISO 1724) in the underride guard at the rear
Floor
Sieve-printed panels approx. 30 mm thick, transverse impact protection with omega inserts, on longitudinal cross members for high point load capacity for forklift axle load up to max. 7100 kg
Front Wall / Front Corner Posts
25 mm aluminum hollow profile, 1650 mm high, corner posts steel in volume design
Front wall additionally covered with 1250 mm high sieve-printed panel on the inside
"Crash blocker", at the bottom inside at approx. 140 mm height with steel ram protection
Storage compartment for plug-in crossbars 80 x 80 on the inside of the front wall
Painting
Fodpfx Aozb Iu Deizsgc
Frame: Hot-dip galvanized including passivation or pa

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.