Open semitrailer

FLIEGL 3-Achs Gardinensattel MegaRunner

Please note: The images shown are archive images. The vehicle may still be in use.

"Preload" – slight preload in the neck area, drawbar coupling with a replaceable 2" kingpin, outer frame slightly angled, new design with "Load-Lock profile" for securing lashing straps, 24 tons, 2-speed landing gear, single-sided operation.
Door lock on the side, support wedges with holder, aluminum side impact protection, galvanized steel under-ride protection, quarter-panel fenders in front of the 1st axle and behind each axle, with anti-splash flaps behind each axle, rear impact protection, pallet stops on both sides, approx. 15-20 mm high, in bolted design, loading height reduced by approx. 15-20 mm, plastic tool box with drawer and insert, b=650 / h=520 / d=670 mm.
Axles + Suspension
SAF disc brake axles, "axle/chassis laser-measured" – reduces tire wear and fuel consumption, air suspension, 1st axle is an automatic lift axle, including forced lowering and start-up assistance, axle lift below the recommended driving height.
Braking system
2-line compressed air braking system, spring-loaded parking brake.
2 fail-safe coupling heads at the front, without connection line, EBS, electronic braking system with EBS socket at the front, without connection cable. Note: with lift and lower valve, ride height in connection with lift axle, when the lift axle is raised, the loading or overall height increases by 50 mm.
Wheels and Tires
435/50 R19.5", steel rims.
Electrical System
24 Volt, multi-chamber lights, 2 white position lights at the front, 2 white/red marker lights at the rear, 2 x 7-pole and 1 x 15-pole fail-safe sockets at the front, without connection cable.
Floor
Sieve-printed panels, approx. 30 mm thick, on longitudinal supports for high point loads, for forklift axle load up to a maximum of 7100 kg.
Front Wall / Front Corner Posts
2580 mm high, corner posts made of steel in a box-section design, release mechanism for side tarpaulin on the front wall.
Itodpfx Abozcmmzjxoh
Intermediate Posts
3 pairs of sliding posts that can be moved along the entire length, with 4-fold insertion pockets and a long pocket at the bottom.
3 pairs of post positions
Insertion strips
5 rows of aluminum insertion strips + Vario strips.
Rear Wall / Rear Corner Posts
Rear corner posts made of steel up to the lower edge of the roof, attachment for tarpaulin with round tube and tarpaulin tensioning ratchet.
Tarpaulin
Tarpaulin with welded-in horizontal and vertical straps, tensioning closures made of stainless steel.
Roof
Fliegl-Blitz sliding tarpaulin, rear end lift that can be folded up, with tarpaulin that can be slid from back to front, L-shaped roof beam for the automotive industry, internal width between the roof beams approx. 2490 mm, tarpaulin color: white (in connection with the sliding tarpaulin, without running carriage at the front).
Country of Approval / Plates
Germany, type approval according to EC 2007/46, 24/7 service hotline, Fliegl manufacturer's certificate for body strength according to EN 12642 XL, Fliegl manufacturer's certificate for body strength according to DL 9.5, pallet stops on both sides, approx. 20 mm high, loading height reduced by approx. 20 mm, Fliegl manufacturer's certificate for load securing according to VDI 2700 Sheet 12 ff., pallet stops on both sides, approx. 20 mm high, loading height reduced by approx. 20 mm, prepared for license plate holder, single row, warning sign according to ECE - 70, reflective strips: white, continuously on the lower part of the

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.