Trailer Swap Chassis

Fliegl 2-Achs Wechselfahrgestell ZWP 180

Attention: The pictures shown are archive images. The vehicle may still be in operation!

Fliegl ZWP 180 Standard – Specifications
Chassis – Swap Body Turntable Trailer
Fine-grain steel welded construction
Front stop, longitudinally adjustable and foldable
Removable guide rollers at the front and rear
Swap Guard – swap body positioning guide, mounted in front of and behind each container locking point
4 container twist locks with heavy-duty outriggers on 20 ft base, suitable for 7.15 m and 7.45 m swap bodies
Heavy-duty turntable with ball bearing race
Wheel chocks with holders
Aluminium side underrun protection
Side underrun protection positioned further inwards for optimum clearance to swap body support legs
Steel rear underrun protection
Shortened underrun protection for optimum clearance to swap body support legs
Protected installation of the lighting system
Quarter fenders at the front and half fenders at the rear
Without rear impact protection
Spare wheel holder in basket design
Plastic toolbox
Drawbar
Drawbar length: 2,200 mm
Drawbar with certified 40 mm towing eye
Spring-assisted drawbar height adjustment
Axles & Suspension
SAF disc brake axles with 430 mm brake discs
Laser-measured axles/chassis alignment to reduce tyre wear and fuel consumption
Air suspension
Braking System
Dual-line air brake system
Colour-coded brake lines for easier servicing
Air reservoir capacity: 208 litres
Spring parking brake
Two colour-coded front coupling heads with connecting lines to tractor unit
EBS electronic braking system with front EBS connector and connecting cable
Note: The trailer may only be operated with towing vehicles that ensure ABS functionality
Raise/lower valve with holding function in both raised and lowered positions
Brake release function via push button on the vehicle next to the raise/lower valve, allowing brake release when coupled
(EBS power supply must be ensured)
Electrical System
24 V electrical system
Multi-chamber lights
Yellow LED side marker lights
Two white front position lights
Two red/white rear outline marker lights
1 × 15-pin front connector with connecting cable
Additional LED work light at the rear, activated via reverse light
LED work light mounted centrally between the chassis beams at the front, illuminating to the rear, activated via reverse light
Registration & Equipment
Country of registration: Germany
DEKRA inspection and approval according to §13 EG-FGV
Prepared for single-line licence plate holder
Warning board according to ECE R70
Foldable ADR warning board at the rear
ECE R48 contour marking with white reflective strips on the sides and red reflective strips at the rear

Bdsdpfxei Ri Dzo Aczof
Attention: The pictures shown are archive images. The vehicle may still be in operation!