Band saw

FAS - Głowno PTS 600 CNC

Cutting range:
Diameter : 650 mm, axh section 800x650 mm
Main drive motor 7,5 kW.
Belt drive unit reducer - inverter.

Body of the machine tool
Bjdovf Icfspfx Ag Iedk
Construction of thick-walled sheets welded and reinforced with steel sections to ensure high stability and durability of the base. In the body there are containers with oil and cooling emulsion. Receiving table at the working vise with dimensions 800x500.

Arm guidance
Vertical columns made of properly selected profile steel. Guiding of the arm - precision rolling guides with preload. Arm movement controlled by two ball screws mechanically connected to each other by reducers and servo motor. The machine will be equipped with a mechanism for hydraulic relief of the arm holding bolts to reduce the pressure on the ball screw nuts, resulting in longer service life. The use of the arm feed drive with ball screws provides constant control over the feed speed especially at minimum cutting speeds, setting the feed speed parameter from the control panel. The machine will be equipped with arm descent speed measurement displayed on the desktop and bend control. The belt guiding control (bend control) will be linked to the arm feed drive mechanism. When the belt deflects, the feed speed will be automatically corrected, after it returns to the correct value, the feed will automatically return to the original value. When the set value of the tape deviation is exceeded (bevel cutting), the machine will stop the cutting process and visually (indicator lamp) will notify the problem.

Standard equipment
Cutting arm guided on rolling guides
Reducer - inverter
Lifting and lowering of the cutting arm controlled by ball screws,
Hydraulic clamping of working vice and feeding vice
Double-half vise holding the material in front of and behind the cutting belt
Bend Control
Hydraulic tensioning of the cutting belt with compensation for its elongation;
Feeding roller table on the body of the machine length of 1.5 mb
Automatic feeder drive screw (single feeding up to 1000 mm) is only available in system with PLC and inverter
Adjustment of clamping force of vices
Roller receiver length 1.5 mb (receiving table)
Feeding table length 3 mb with driven rollers equipped with vertical rollers on the input and output - controlled from the machine desktop (additionally equipped with a mobile desktop at the roller conveyor)
Laser cutting line
Chip extractor (directed to the right side)
PLC with liquid crystal display; cutting belt speed measurement (NC)
Full protection, complying with CE safety mark.
Cooling system;
Cutting belt; DTR

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.