Notching saw

elumatec AKS 134

Variable notching possibilities for mullion and transom combinations, e.g. for curtain walls, conservatories, sky lights, and special designs
Precise and safe notching is ensured because the workpiece is fixed and only the saw units move
Both saw units are adjusted in height simultaneously by means of a hand wheel (analogue display on the hand wheel)
The cutting depth is set using an analogue display
Manual angle adjustment of the saw blades using a digital display of the tilting angles
Support table with compound slide and pivoting back fence is manually adjustable for optimal use of the cutting range
The angle of the pivoting back fence is shown on a digital display
Horizontal and vertical profile clamping
Automatic working cycle at a 90° pivoting angle (two-hand control when cutting special angles)
Hydro-pneumatic saw feed

Lower saw unit (vertical):

Saw blade diameter 550 mm
Tilting range from 45° forwards to 60° towards the rear
Max. cutting height of 210 mm
Power supply 230/400 V, 3~, 50 Hz
Power output 3 kW with motor brake
Saw blade speed 2,800 rpm
Manual tilting angle adjustment with digital display
Upper saw unit (horizontal):

Saw blade diameter 500 mm
Tilting range from 55° downwards up to 60° upwards
Hjdpfxsyfhvpe Agbeni
Notching depth, max. 190 mm
Power supply 230/400 V, 3~, 50 Hz
Power output 3 kW with motor brake
Saw blade speed 2,800 rpm
Manual tilting angle adjustment with digital display
Travel 830 mm max.
Support table with working height of 990 mm:

Pivoting range from 30° left to 30° right, home position 0°
Pivoting range manual with digital display
Compressed air supply 7 bar
Air consumption per working cycle 35 l without spraying, 45 l with spraying
Length 3,000 mm, depth 1,420 mm, height 1,600 mm, weight 1,250 kg