Drill grinder

ELMAG DBG 832 W

ELMAG drill grinder DBG 832 W
8 - 32mm

DBG - 3 in 1
The DBG series drill grinder is used for grinding twist drills made of
HSS and carbide twist drills. The machine has integrated grinding stations for grinding the point angle, the clearance angle and for cross grinding.

Special CBN or SDC diamond grinding wheels are used, which are to be used depending on the drill material.
material.
SDC coated grinding wheels
Metal-coated synthetic diamond for sharpening carbide drills.
CBN coated grinding wheels
Deliver sensational sharpening results at very high speed and without annealing. The special thermal conductivity of CBN (boronite crystals) dissipates the resulting frictional heat into the wheel, preventing hardening of the cutting edge and virtually eliminating sparking. CBN has a higher thermal stability than diamond and is ideal for sharpening HSS tools due to lower wear.

Optionally available:
Grinding wheel SDC for DBG 832 W Order no. No. 61016
Collet chuck holder for Ø 31-32 mm for DBG 832 W
Collet set (ER40) 2-piece, Ø 31-32 mm for DBG 832 W

Now free of charge with both models
Collet holder and collet set ER 20 or ER 40

ADVANTAGES
CBN grinding wheel for HSS
Adjustment device for center angle 95°-135
Clearance angle grinding function
Cross grinding function
For drill bits 8-32 mm
23 collets 8-30 mm

Fjdpfxst Hhg No Ah Sepc
TECHNICAL DATA
Grinding range drill bit Ø 8 - 32 mm
Grinding range point angle 95 - 135 °
Speed 4400 rpm
Motor power 0.25 kW
Mains connection 230/50 V/Hz
Length 490 mm
Width 250 mm
Height 260 mm
Weight 27 kg

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.